Electrolux FEH 610 Electrical connections, Building over a kitchen unit with door, Sealing gasket

Building over a kitchen unit with door

Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be hot when in operation. The recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.

3		30
	a	min
60		20
	b

FO 1013

Dimensions are given in mm.

Fitting the Hob into the worktop

Carry out the building in of the hob as follows:

)• put the seals supplied with the hob on the edges of the cut out, taking care that the seals meet without overlapping;

•place the hob in the cut out, taking care that it is centred;

•fix the hob with the relevant fixing clamps and screws, as shown in the diagram. When the screws have been tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents the ingress of liquids.

a

FO 0199

a) Sealing gasket

Electrical connections

Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these safety measures not be observed.

This hob is designed to be connected to a 230-240V 50Hz

AC electrical supply.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the hob rating plate. The rating plate is located on the bottom of the hob. A copy is attached on the back cover of this book.

10