Electrolux 318 203 603 (0709) manual About the Radiant Surface Elements

12Before Using the Cooktop

ABOUT THE RADIANT SURFACE ELEMENTS

The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle ON and OFF. The heating element retains enough heat to provide a uniform and consistent heat during the OFF cycle. For efficient cooking, turn OFF the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.

NOTE

Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI setting. This helps to prevent damage to the ceramic glass cooktop. Cycling at the HI setting is normal and can also occur if the cookware is too small for the radiant element or if the cookware bottom is not flat (Refer to pages 15-16 for using correct cookware instructions with the cooktop).

Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning section and Solutions to Common Problems section of this Use and Care Guide.

LED MESSAGES DISPLAYED BY RADIANT ELEMENT CONTROLS

Fig. 1 Fig. 2

Fig. 3 Fig. 4

Fig. 5 Fig. 6

Fig. 7 Fig. 8

THE AVAILABLE WINDOW DISPLAY SETTINGS - The control will display heat levels ranging from Hi (Figure 1) to Lo (Figure 6) and OFF (Figure 7). The settings between 9.5 (Figure 2) and 3.0 (Figure 3) decrease or increase in increment of .5 (1/2). The settings between 3.0 (Figures 3 & 4) and 1.2 (Figure

5)are Simmer settings which decrease or increase in increment of .2 (1/5) to Lo (Figure 6; lowest Simmer setting) for more precise settings at lower heat levels. Use the Recommended Surface Setting Chart to determine the correct setting for the kind of food you are preparing.

HOT ELEMENT INDICATOR MESSAGE (HE) - After using any of the single or dual radiant element positions the cooktop will become very hot. Even after turning the control to OFF, the cooktop will remain hot for some time. The control monitors the temperature of the cooktop and displays the message “HE” (hot element; See Fig. 8) warning when the cooktop is still too hot to touch. If the HE message appears in the window, the control can still be turned ON again for use.

LOCKOUT FEATURE (- -) (See controls lock on page 11) - Whenever the Cooktop Lockout feature is active, "- -" will appear in each radiant element display windows (See Fig. 9).

KEEP WARM (LH) - Use the keep warm key pad to activate the warm settings for any of the cooking zones. The ON/OFF key pad for the desired cooking zone must be activated first, then touch the warm key pad once to set the Keep Warm function. LH (Low Heat) should appear in the corresponding cooking zone display window (See Fig. 10).

Fig. 9 Fig. 10