Electrolux C 718 40-4i installation instructions Symptom Possible Cause Remedy

Page 16

Symptom

 

Possible Cause

 

Remedy

 

 

 

 

 

 

 

Appliance is not switched on

 

 

 

 

 

Mains plug is not plugged in

Appliance does not work.

 

or is loose.

 

 

 

Fuse has blown or is defective.

 

 

 

 

 

 

 

 

 

 

Socket is defective.

 

 

 

 

 

 

Appliance cools too much.

 

Temperature is set too cold.

 

 

 

 

 

 

 

Temperature is not properly

 

 

adjusted.

 

 

 

 

 

Door was open for an exten-

 

 

ded period.

The food is too warm.

 

 

 

A large quantity of warm food

 

 

was placed in the appliance

 

 

within the last 24 hours.

 

 

 

 

 

The appliance is near a heat

 

 

source.

 

 

 

Interior lighting does not work. Light bulb is defective.

Switch on the appliance.

Insert mains plug.

Check fuse, replace if neces- sary.

Mains malfunctions are to be corrected by an electrician. Turn the temperature control knob to a warmer setting. Please look in the "Initial Start Up" section.

Open the door only as long as necessary.

Turn the temperature control knob to a colder setting.

Please look in the "Installation location" section.

Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than

Heavy build up of frost, possi- bly also on the door seal.

The compressor does not start immediately after changing the temperature setting. Water on the floor or on sto- rage shelves.

Door seal is not air tight (pos- sibly after reversing the door).

This is normal, no error has occurred.

Water drain hole is blocked.

approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.

The compressor starts after a period of time.

See the "Cleaning and Care" section.

If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.

In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

16

Image 16 Contents
Santo C 7 18 Dear customer Who thinks ecologically acts accordinglyContents Safety Safety of childrenIntended use Prior to initial start-upService DisposalDaily Operation Appliance packaging informationDisposal of Old appliances Remove Transport PackagingShelf Holders Description of the Appliance Movable shelfGlass shelves Glass shelfStarting Up and Temperature Regulation Setting 0 OffInterior Accessories Storage ShelvesVariable Inner Door Variable Storage BoxFresh Food Refrigeration Freezing and Storing Frozen Food Storage goods symbols/freezing calendar Ice packPreparation of ice cubes There is an ice pack in one drawer of the freezerDefrosting FrostSwitching Off the Appliance Cleaning and CareEnergy Saving Tips When everything is dry switch the appliance back onSomething Not Working Symptom Possible Cause Remedy Switch the appliance back on Changing the light bulbService and Spare Parts Customer Care DepartmentGuarantee Conditions Installation Electrical ConnectionYour appliance needs air PositioningReversing the door Housing dimensions HeightDepth WidthInstructions for building-in 44 mmApply covers B into the relevant holes Separate parts A, B, C, D as shown in the figureFix cover C on guide a until it clips into place Fix cover D on guide B until it clips into place Regulations, Standards, Guidelines AEG