Fastening to the wall

Warning!

The appliance must be fastened to the wall for safety reasons.

Take the bag supplied with the appliance. It contains the following accessories:

2 brackets

4 wall plugs (for fixing to masonry wall)

4 wall plugs (for fixing to dry lined walls)

4 screws

Proceed as follows to carry out the fastening:

1.Find the appliance’s positioning center.

2.Measure 200 cm from the floor. At the point where the height and the centre meet measure 15 cm to right and 15 cm to the left. Make two 8 mm holes on the left with a drill bit.

3.Repeat the operation on the right with the drill (see figure).

For masonry walls:

4.Insert the 4 metal wall plugs and tighten the screws.

5.Fasten the brackets horizontally in the lower set of holes as illustrated in the figure after having previously removed the screws.

6.Push the appliance towards the wall and turn the brackets downwards 90°. Make sure that the lower part of the brackets is located between the appliance and the plate.

7.Insert the second set of screws in the upper holes and complete the fastening.

For dry lined walls:

4.Insert the wall plugs by screwing them into the holes drilled previously.

5.Fasten the brackets horizontally in the lower set of holes with the screws as illustrated in the figure.

6.Push the appliance towards the wall and turn the brackets downwards 90°. Make sure that the lower part of the brackets is located between the appliance and the plate.

7.Tighten the screws previously loosened and complete the fastening with the second set of screws.

Once the appliance is fastened to wall, make sure that it is stable.

15 cm 15 cm

1,5cm

200 cm

D742

15 cm

1,5 cm

200 cm

D753

90°

D743