Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
The food is too warm.
Interior lighting does not work.
Heavy build up of frost, possibly also on the door seal.
Unusual noises.
Temperature is not properly adjusted.
Door was open for an extended period.
A large quantity of warm food was placed in the appliance within the last 24 hours.
The appliance is near a heat source.
Light bulb is defective.
Door seal is not air tight (possi- bly after reversing the door).
Appliance is not level.
The appliance is touching the wall or other objects.
Please look in the "Initial Start Up" section.
Open the door only as long as necessary.
Turn the temperature regulator to a colder setting.
Please look in the "Installation location" section.
Please look in the "Changing the Light Bulb" section.
Carefully warm the non sealing sections of the door seal with a hair dryer (not hotter than approx. 50 °C). At the same time shape the warmed door seal by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
The compressor does not start
immediately after changing the This is normal, no error has occurred.
temperature setting.
Water on the floor or on stora- Water drain hole is blocked. ge shelves.
The compressor starts after a period of time.
See the "Cleaning and Care" section.
If after all these checks your appliance does not operate correctly, contact your local AEG Service Force Centre.
Please note that it will be necessary to provide proof of purchase for any in- guarantee service calls.
15