Something not Working

Replacing The Oven Light

Disconnect the appliance.

If the oven bulb needs replacing, it must comply with the following specifications:

Electric power: 15 W/25 W; Electric rate: 230 V (50 Hz); Resistant to temperatures of 300°C; Connection type: E14.

These bulbs are available from your local Service Force Centre. To replace the faulty bulb:

1. Ensure the oven is disconnected from the electrical supply.

2. Turn the glass cover counterclockwise.

3. Remove the faulty bulb and replace with the new one.

4.Refit the glass cover and restore the electrical supply.

If the appliance is not working correctly, please carry out the following checks, before contacting your local Service Force Centre.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

SYMPTOM

SOLUTION

"The oven does not come on.# Check that both a cooking function and temperature have been selected.

#Check the appliance is wired in properly, and the socket switch or the switch from the mains supply to the oven are ON.

#Check that the time of day has been set with the electronic programmer.

"The oven temperature light does not # Select a temperature with the thermostat

come on.	control knob.
	# Selectafunctionwiththeovenfunctioncontrol
	knob.

"The oven light does not come on. # Selectafunctionwiththeovenfunctioncontrol

knob.

# Checkthelightbulb,andreplaceitifnecessary (see paragraph "Replacing The Oven Light").

" It takes too much time to finish the dishes,	# The temperature may need adjusting.
or they are cooked too fast.	# Refertothecontentsofthisbooklet,especially
	to the chapter “Using the Oven”.

"Steam and condensation settle on the # Leave dishes inside the oven no longer than

food and the oven cavity.

15-20 minutes after the cooking is completed.

"The oven fan is noisy.# Check that shelves and bakeware are not vibrating in contact with the oven back panel.