Electrolux EON 30620 user manual Connecting the terminal board, Electrical connection with the hob

does not reach at any given point a temperature 50°C higher than the ambient temperature.

Suitable power supply cables are the following types, considering the respective necessary section of cable: H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

Connecting the terminal board

The appliance incorporates an easily accessible 6-pole terminal board whose jumpers (bridges) are already pre-set for operation on 400 V tri-phase with neutral wire (Fig. 19). In case a different mains voltage is present, the jumpers on the terminal board must be rearranged as shown in the diagram (Fig. 20). The ground cable must be

connected to terminal . After connecting

the supply cable to the terminal board, secure it with a junction clamp.

Electrical connection with the hob

This oven can be connected to hobs indicated in the paragraph "Technical data". The socket for connecting the hob is located at the top of the oven cabinet. The hobs come complete with connecting leads for the hot plates/heat areas and ground cable; these leads feature plug-in connectors. Connection of the hob to the oven is carried out by plugging-in these connectors to the corresponding oven socket.

The plug-to-socket connection design is such as to prevent possible wrong plugging-ins.

The Manufacturer disclaims any liability in case these accident-preventing rules are not observed.

							Fig. 19
	230V 3~	1	2	3	4	5
Ø 4x2,5mm²
		L1		L2		L3 PE
	230V 1~	1	2	3	4	5
Ø 3x2,5mm²
		L1			N			PE
	400V 2N~	1	2	3	4	5
Ø 4x2,5mm²
		L1 L2			N				PE
	400V 3N~	1	2	3	4	5
Ø 5x1,5mm²									PE
		L1 L2 L3 N

Fig. 20

electrolux 53