Position drip cups:
When using the
Griddler as a Contact
Grill or Panini
Press, only one drip cup is
needed. Place the cup directly below the grease spout while cooking. Grease from the food will run off the plates through the grease spout and into the drip cups. Grease should be safely disposed of after cooking. The drip cups can be cleaned in the dishwasher.
When using the Griddler as an Open Grill or Griddle, both drip cups should be used. Place the cups at either end of the unit directly below the grease spouts.
Once the Griddler is assembled properly,
plug the cord into a standard electrical outlet. You are now ready to begin cooking.
OPERATING
INSTRUCTIONS:
Once the Griddler is assembled properly and you are ready to begin cooking, turn the Selector to the left to choose the Griddle function or to the right to choose the Grill/Panini function, depending on what you intend to cook. When the knob is turned to either function, a red indicator light will illuminate to indicate that the power is on.
If you intend to use the Griddler as a Contact Grill, Panini Press or Flat Grill, turn the Grill/ Panini Control to the desired temperature for cooking. Settings range from Warm (65°C) to Sear (230°C).
If you intend to use the Griddler as a Griddle, turn the Griddle Control to the desired temperature for cooking. Temperature settings range from 95°C to 220°C.
If you intend to use the Griddler as a Flat Grill
or Griddle, but you do not need the entire surface, use the bottom plate.
It may take up to 10 minutes to reach operating temperature, depending on the temperature level that was set. When the thermostat has reached operating temperature,a green indicator light inside the chosen control will indicate that the Griddler is ready for cooking. During operation, the light will continue to turn on and off as the thermostat regulates the temperature. This is normal.
The temperature controls are used to set and maintain the temperature of the cooking surface. You may vary the setting of the control knob at any time during cooking, and may wish to do so depending on the types of foods on the cooking plate. Refer to the Cooked Food Temperature Chart on page 17 of the Recipe Book for recommendations.
Always exercise caution when handling the Griddler during cooking. To open the Griddler grasp the black plastic area of the handle. This part of the handle stays cool to the touch while cooking. The arms are made of die-cast aluminum and will become hot during use. Do not touch them during or immediately following cooking.
The Griddler housing will become hot during use. The cover is made of stainless steel and will become very hot and should not be touched during or immediately following cooking. If you need to adjust the cover be sure to use an oven mitt to prevent burns.
The lower housing is made of plastic, and while it will become very warm it will not burn you. If you need to move the Griddler during cooking be sure to handle it from the base only. Do not touch
the cover.
Allow the Griddler to cool down before handling (at least 30 minutes).
NOTE: The first time you use the Griddler,
it may have a slight odour and may smoke a bit. This is normal and common to appliances with nonstick surfaces.
The Griddler comes with a black cleaning/scraping tool.This can be used for cleaning the grill and griddle plates after you have finished cooking and the unit has cooled down completely (at least 30 minutes). Using the cleaning tool on a hot surface for too long will cause the plastic to melt.
User Maintenance:
*Never use metal utensils, as they will scratch the nonstick plates. Instead, use only wooden or heat-proof plastic utensils.
*Never leave plastic utensils in contact with the hot grill plates. This includes the provided cleaning tool.
*In between recipes, scrape excess food buildup through grease channels and into drip cups, then wipe off any residue with a paper towel before proceeding with next recipe.
*Allow the Griddler to cool down completely (at least 30 minutes) before cleaning.
CLEANING AND CARE:
CAUTION: BEFORE CLEANING APPLIANCE, MAKE SURE IT HAS COOLED DOWN COMPLETELY.
Once you have finished cooking, turn the Selector Control to the OFF position and unplug the power cord from the wall outlet. Allow the unit to cool down for at least 30 minutes before handling.
Use the cleaning/scraping tool to remove any leftover food from the cooking plate. The scraping tool can be washed by hand or in the dishwasher.
Dispose of grease from drip cups. The drip cups can be cleaned by hand or in the dishwasher.
Press the Plate Release Buttons to remove plates from the housing. Be sure that the plates have cooled completely before handling (at least 30 minutes). The cooking plates can be washed in