UTILITY
REQUIREMENTS
GAS
Not applicable
ELECTRICAL
•6’ (1.8 m),
•120 VAC/60 Hz
•Maximum amp
•
PLUMBING
KITCHEN CLEANUP
Undercounter 24”W. Dishwasher
Installation Requirements
ACCESS REQUIREMENTS
DFUD042P/142P | DFUD042D/142D | DFUD042/142 |
Professional | Designer | Custom Front |
|
| See Custom Panels section for |
|
| more information and additional |
|
| specifications. |
•120°F (49°C) hot water recommended; dishwasher will, however, perform properly with cold water (Cycle times will vary)
•Inlet water pressure operating
– 176 psi (125 – 1,227 kPa)
•
(1.9 cm) ID “crimp- proof” rubber drain hose with clamp attached to dishwasher; can be extended up to a maximum of 10’ (3.0 m) with 3/4” (1.9 cm) ID copper tubing
•High loop of drain hose required; min. height from floor— 24” (61.0 cm); max.
•6’ (1.8 m) PEX water line with 3/8” (0.95 cm) compression fitting (NPT female connection) supplied with unit
•Check local codes for drain air gap requirement
24” | 24”* | ||
(61.0 cm) | |||
(61.0 | cm) | ||
| |||
|
|
34- |
|
|
1/4” | min. | |
(87.0 |
| |
cm) | ||
37” max. | ||
(94.0 | cm) | |
|
Note: A
*When installing the dishwasher without the side trim, the cutout must be
|
| All models |
Cutout width |
| 24” (61.0 cm) |
Cutout height | ||
Cutout depth |
| 24” (61.0 cm) |
P L A N N I N G A N D D E S I G N G U I D E | R E L E A S E D 1 2 / 1 / 0 7 | |
V I K I N G R A N G E . C O M | • 1 - 8 8 8 - V I K I N G 1 | © 2 0 0 7 V R C — INFORMATION SUBJECT TO CHANGE |