Viking F20508 manual Electrical Connection 4-wire

Electrical Connection (4-wire)

WARNING

Electrical shock hazard. To avoid risk or electrical shock, personal injury or death; grounding product to the frame

of the unit may or may not be permitted through your local codes. If ground to the frame is not permitted then a 4 conductor power cord must be used.

WARNING

Electrical shock hazard. To avoid risk of electrical shock, personal injury or death; verify your appliance has been

properly grounded in accordance with local codes or in absence of codes, with the National Electrical Code (NEC). ANSI/NFPA 70-latest edition.

4	5
	1

2

Feed supply cord up through hole in bottom	Attach ground lead (green)
of range back.	with ground screw that was removed.

Use a 4-wire power supply cord kit rated for 60 amps – 125/250 volts with closed loop terminals and marked for use with ranges.

DO NOT use a GFI circuit. Where local codes do not permit grounding through neutral, use a 4-wire power supply cord. The cord or conduit must be secured to the range with the strain relief bracket.

The electrical connection is made at the terminal block, which is located behind the access door on the back of the range.

1

2

1

Remove access door.

6

1

2

Attach line #1 (red) and line #2 (black) leads to outside terminal. Attach neutral wire (white)

to center terminal on terminal block.

7 1

3

Push supply cord toward terminal block to relieve strain, reattach supply cord strain

relief bracket over supply cord.

2		3
3		2
1		1
2
	Remove supply cord strain relief		Remove grounding screw. Cut-off
bracket and three supply cord mounting screws			and discard ground strap.
	on the terminal block.

8

1

2

Reattach access door.

14 15