Installation
Connect to Water Line (cont.)
6.Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the 1/4" drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so washer makes a watertight seal. DO NOT overtighten or you may crush the copper tubing.
7.Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. DO NOT overtighten.
8.Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper tubing.
Connect to Refrigerator
1.Create a service loop (minimum diameter of 2 ft. [61.0 cm]) with the copper tubing. Avoid kinks when coiling the copper tubing.
2.Remove the plastic cap from water valve inlet port. Place a compression nut and sleeve on the copper tubing.
3.Insert the end of the copper tubing into the water valve inlet port. Shape tubing slightly so that the tubing feeds straight into the port to avoid kinks.
4.Slide the compression nut over the sleeve and screw into the water valve inlet port.
| A |
| B |
| C |
| D |
A. Plastic water tubing | C. Compression nut |
B. Sleeve | D. Copper tubing |
5.Using an adjustable wrench, hold the nut on the plastic water line to keep it from moving. Then, with a second wrench, turn the compression nut on the copper tubing counterclockwise to completely tighten. Do not overtighten.
A
B
C
D
A. “P” clamp | C. Compression nut |
B. Plastic water line | D. Copper tubing |
6.Check connection by pulling on copper tubing. Attach copper tubing to refrigerator cabinet with a “P” clamp. Turn on water supply to refrigerator and check for leaks. Correct any leaks.
Leveling
To enhance the appearance and maintain performance, the refrigerator should be level. To protect property and refrigerator from damage, observe the following:
•Protect vinyl or other flooring with cardboard, rugs, or other protective material.
•DO NOT use power tools when performing leveling procedure.
Materials Needed
•1/4” hex head driver
•Carpenter’s level
Note: Complete any required panel installation and/or water supply connection before leveling. Refrigerator should be in permanent location prior to leveling.
1 | 2 |
Remove toe grille. Grasp firmly and pull outward | To raise the front of the refrigerator,turn the leveler foot |
to unclip. | screw clockwise. Note: Having someone push against the |
| top of the refrigeratortakes some weight off the leveler |
| foot screws. |
3 | 4 |
|
|
|
|
|
|
|
|
|
|
|
|
To lower the front of the refrigerator, turn the leveler foot | Replace toe grill. Align the toe grille mounting clips | ||
screw counterclockwise. Note: It may take several turns | with the lower cabinet slots. Push the toe grille firmly | ||
of the leveler foot screw to adjust the tilt of the | until it snaps into place. Check for level. | ||
refrigerator. |
|
| |
18 | 19 |