Viking VRBD/VUBD 24" W. BEVERAGE DISPENSER Cleaning and Maintenance, Service Information, Cabinet

Page 14

CLEANING AND MAINTENANCE

Condenser

The condenser tubing under the cabinet for forced air units does not require frequent cleaning. However, satisfactory cooling depends on adequate ventilation over the condenser. Be sure that nothing obstructs the air flow openings in the lower front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grill on the bottom front of the cabinet.

Cabinet

The painted cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring powders.

Interior and Door Gasket

Wash interior compartment with mild soap and water. Mix 2 tablespoons of baking soda with one quart of warm water. Do not use an abrasive powder, solvent, polish cleaner or undiluted detergent.

SERVICE INFORMATION

It is assumed that your beverage dispenser has been properly installed in accordance with all specifications and local codes. If your beverage dispenser should fail to operate, review the common draft problems before calling for service.

If service is required:

1.Call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area.

2.Have the following information readily available:

•Model Number

•Serial Number •Date of purchase

•Name of dealer from whom purchased.

3. Clearly describe the problem that you are having.

If you are unable to obtain the name of an authorized service agency, or if you continue to have service problems, contact Viking at (888) 845-4641 or write to:

VIKING PREFERRED SERVICE

111 Front Street

Greenwood, Mississippi 38930 USA

Record the information indicated below. You will need it if service is ever required. The model and serial number for your beverage dispenser is located on the front of the unit at the base of the door frame.

Model Number

 

 

 

Serial Number

 

Date of Purchase

 

 

Date Installed

 

Dealer’s Name

 

 

 

 

Address

 

 

 

 

If service is requires installation of parts, use only authorized parts to ensure protection under the warranty.

This manual should remain with the beverage dispenser for future reference.

14

Image 14
Contents CO2 can be Dangerous Important Please Read and FollowGeneral Information Before YOU Throw Away Your OLD Refrigeration Product BUILT-IN InstallationElectrical Connection Casters Level UnitTOP Dimensions Freestanding ModelsFront Cabinet Cutout Undercounter Models Rear WallTOP Dimensions Undercounter ModelsFront Side Assembly How to Replace an Empty CO2 Cylinder CO2 RegulatorTwin Probe KEG Taps Tapping ProceduresSankey Type KEG Coupler Approximate Measurements Required to TAP Most KegsGeneral Tips and Suggestions Drain Hose and ContainerFinal Preparation Operating Instructions Wiring Diagram 24 W. Refrigerated Beverage DispenserSetting the Control HOW to Draw the Perfect Glass of Beer Description Causes Common Draft ProblemsEnergy Saving Tips Condenser Cleaning and MaintenanceService Information CabinetProfessional Series 24 W. Beverage Dispenser Warranty ONE Year Full WarrantySpecifications subject to change without notice