Viking F20050 EN manual Important Please Read and Follow, For Your Safety, General Information

Page 2

IMPORTANT - PLEASE READ AND FOLLOW

•Before beginning, please read these instructions completely and carefully.

•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.

•Please observe all local and national codes and ordinances.

•Please ensure that this product is properly grounded.

•The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future reference.

WARNING:

To reduce the risk of fire, electrical shock, or injury when using your wine cellar, follow basic precautions including the following:

•FOR YOUR SAFETY•

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.

It is your responsibility to be sure your wine cellar is:

•located so the front is not blocked to restrict incoming or discharge air flow. •properly leveled.

•located in a well ventilated area.

•connected to the proper kind of outlet, with the correct electric supply and grounding. A 115 volt, 60 Hz, 15 amp fused electrical supply is required. NOTE: Time delay fuse or circuit breaker is recommended.

•not used by anyone unable to operate it properly. •used only for its intended purpose.

•properly maintained.

•SAVE THESE INSTRUCTIONS•

PROPER DISPOSAL OF YOUR OLD REFRIGERATION UNIT

DANGER

SUFFOCATION HAZARD

Remove doors from your old refrigeration unit. Failure to do s o can result in ch ild entrapment, which can cause death or brain damage.

IMPORTANT: Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigeration products are still dangerous, even if they will sit for “just a few days.” If you are getting rid of your refrigeration product, please follow the instructions below to help prevent accidents.

BEFORE YOU THROW AWAY YOUR OLD REFRIGERATION UNIT: •Take off the doors.

•Leave the shelves in place so that children may not easily climb inside.

GENERAL INFORMATION

Unpack

1.Remove banding from bottom of carton. Lift carton up and off of the wine cellar

2.Remove all tape and packaging material from the outside and inside of the cabinet.

3.Keep all carton packaging until your wine cellar has been thoroughly inspected and found to be in good condition.

AREA REQUIREMENTS

1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.

2.Unit should be in a well ventilated area with temperature above 55°F (13°C) and below 110°F (43°C). Best results are obtained at temperatures between 65°F (18°C) and 80°F (27°C) for built-in models and 65°F (18°C) and 90°F (32°C) for freestanding models.

3.Provisions for electricity should be determined before placing unit in proper place.

Units Certified for Outdoor Use - (stainless steel outer cabinet)

1.Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved for servicing if necessary.

2.Unit should be in a well ventilated area with temperature above 40°F (4.4°C) and below 110°F (43°C). Best results are obtained at temperatures between 60°F (16°C) and 100°F (38°C).

3.Provisions for electricity should be determined before placing unit in proper place.

UNDERCOUNTER CABINET CUTOUT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

15” W. Models

24” W. Models

 

 

 

 

 

A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A

15” (38.1 cm)*

24” (61.0 cm)*

 

 

 

 

 

 

B

Min. 34 1/2” (87.6 cm)

Min. 34 1/2” (87.6 cm)

 

 

B

 

 

C

 

Max. 35 1/8” (89.2 cm)

Max. 35 1/8” (89.2 cm)

 

 

 

 

 

 

 

 

 

C

24” (61.0 cm)

24” (61.0 cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

*Add 1/4” (.64 cm) to cutout width if door is recessed between cabinets.

2

3

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Viking Use/Installation Guide F20050 EN 031408J 41010897Proper Disposal of Your OLD Refrigeration Unit For Your SafetyImportant Please Read and Follow General InformationFront View SPECIFICATIONS/DIMENSIONS Professional 15 W. ModelsSPECIFICATIONS/DIMENSIONS Designer 15 W. Models Side ViewDesigner 24 W. Models SPECIFICATIONS/DIMENSIONSProfessional 24 W. Models 47 1/4 120.0 cmDfuw Model Selecting and Preparing the Wood Frame 15 W. Dfuw ModelSelecting and Preparing the Wood Frame 24 W. Dfuw Model Attaching the Handle Attaching the Wood Frame to the Door Dfuw ModelElectrical Connection Lock Installation DetailsRead before installing leg levelers Final PreparationLight Assembly REPLACEMENT- 15 W. Models Light Tube Replacement 24 W. ModelsGlass Door Models Settingthe ControlsSolid Door Models Stacked on top of each Loading Recommendations 15 W. ModelsLoading Recommendations 24 W. Models Problem Possible Cause Solution Cleaning and MaintenanceTroubleshooting Chart Plug unit into power sourceService Diagnostics Units Certified for Indoor Use Service InformationUNDERCOUNTER/FREESTANDING Wine Cellar Warranty Front Street Greenwood, Mississippi 38930 USAUNDERCOUNTER/FREESTANDING Wine Cellar Warranty

F20050 EN specifications

The Viking F20050 EN is a standout model in the realm of electric lawn mowers, designed to provide efficient performance and user-friendly features for a diverse range of garden sizes. This machine redefines lawn care by combining cutting-edge technology with ergonomic design, making it an essential tool for both amateur gardeners and professionals.

One of the most notable features of the Viking F20050 EN is its powerful electric motor. With a capacity that delivers consistent power, the mower is capable of cutting through thick grass and uneven terrain with ease. The electric motor not only minimizes emissions but also ensures a quieter operation, making it an environmentally friendly choice for maintaining lawns.

The mower incorporates an innovative cutting system with a robust blade that balances efficiency and precision. Its design allows for adjustable cutting heights, providing flexibility to achieve the desired length of grass while accommodating various types of terrain and grass species. This feature is particularly beneficial for homeowners seeking a polished, manicured look for their yards.

Another characteristic that enhances the user experience is the ergonomic handle, designed to reduce strain during extended use. The handle can be adjusted to suit the user's height, ensuring comfort and control while maneuvering the mower. The model also includes a foldable design, which makes storage and transport more manageable, addressing the needs of those with limited space.

The Viking F20050 EN is equipped with a spacious grass catcher that reduces the frequency of emptying during mowing sessions. This system enhances productivity, allowing users to cover larger areas without interruption. Additionally, the mower's intelligent design includes a mulching feature, enabling the recycling of grass clippings back into the lawn, thus providing natural fertilization and promoting healthy growth.

Durability is another key characteristic that Viking incorporates into this model. Constructed with high-quality materials, the F20050 EN withstands the rigors of regular use and harsh weather conditions, ensuring a long service life. Its simple yet effective maintenance requirements make it a convenient choice for users who prefer a hassle-free lawn care solution.

Overall, the Viking F20050 EN stands as a versatile, efficient, and environmentally conscious choice in the electric lawn mower market. Its features cater to the needs of diverse users, making it a reliable companion for maintaining a beautiful lawn.
Top Page Image Contents