Wok Conversion
(for models equipped with wok)
Overhead
View
Air Shutter
Orifice
Remove center trivet and/or grates, center ring and grate support. Lift and remove burner from unit.
Loosen air shutter screw and adjust opening on burner to 5/8” and tighten air shutter screw. Remove orifice by turning counterclockwise and replace with orifice from bag labeled Wok Orifice.
IMPORTANT: The orifice tip must be located 3/16” inside the burner for proper gas mixture and combustion. The depth of the orifice can be adjusted by turning the orifice counterclockwise (more depth) or clockwise (less depth).
Reverse procedures as needed to reassemble.
Bake Conversion
“L” Shaped
Remove oven racks and rack supports.
Remove oven bottom by sliding toward rear of range, then lift upward. Remove screws securing toe grille to unit.
Remove screws securing burner support bracket to frame of unit and remove burner support bracket.
Slide bake burner to the left off of orifice and pull bake burner straight out through available clearance.
Loosen air shutter screw and adjust opening on burner to 7/16” and tighten air shutter screw. Remove orifice by turning counterclockwise and replace with orifice from bag labeled Oven Burner Orifice
IMPORTANT: The orifice tip must be located 3/16” inside the burner for proper gas mixture and combustion. The depth of the orifice can be adjusted by turning the orifice counterclockwise (more depth) or clockwise (less depth).
To reinstall burner, position rear of burner into slot on rear wall of burner box then place front of burner onto orifice.
Reverse procedure as needed to reassemble.
16 | 17 |