Viking VCCM12 manual Setting the programmed time, Water Reservoir Icon

Setting the programmed time

•Press the PROG (Program) button once until the PROG display appears.

•Press the CUPS button until the desired number of cups is reached.

•Press the PROG button once until the Bell icon is displayed.

•Press Hour (H) or Minute (M) button to set the desired program time. If buttons are held down this will cause fast advance of hour and minute display.

•Press the PROG button again, bell icon on and PROG icon off. Hour and Minute display will go back to clock display.

•The Bell icon will be displayed to indicate program mode has been activated.

•When this time is reached, the heater will heat the water, the pump will start to cycle, and brewing automatically begins at the designated time.

•To discontinue the program feature, simply press the PROG button until the Bell icon disappears.

•The clock program time must be reprogrammed after power is lost, due to a power outage, or being unplugged.

Clock and Program Time

Program Icon

Icon is lit when PROG time is shown for setting program time

Cup Select Icon

Number of cups to be brewed (4-12 Cups)

Bell Icon

Unit is programmed to brew at set time
Water Reservoir Icon
	On: Water is heating
Flashing:	Water reservoir
is not filled, properly installed,
or unit may need to be descaled

Brew Basket Icon

Flashing: Brew basket is not properly installed

Brew Icon

On: Coffee Maker is now brewing

Hour Display/Clock Display			Program
Minute Display/Cup Select 4-12		Brew
	On/Off

Note: If icons continue to blink, the parts are not properly installed and must be removed and properly replaced before brewing begins.

10