2 Wall Construction
This
To find the location of the studs, one of the following methods may be used:
•Use a stud finder, a magnetic device which locates the nails in the stud.
•Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. The center of any adjacent studs will normally be 16” or 24” to either side of this mark.
3Electrical Grounding
Instructions
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current.
WARNING: Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The oven is equipped with a
DO NOT USE AN EXTENSION CORD.
If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the appliance.
The Power Supply Cord and plug must be connected to a separate 120 Volt AC, 60 Hz, 15 Amp, or more branch circuit, single grounded receptacle. The receptacle should be located inside the cabinet directly above the
NOTE:
•If you have any questions about the grounding or electrical instructions, consult a qualified electrician or serviceperson.
•Neither Viking nor the dealer can accept any liability for damage to the oven or personal injury resulting from failure to observe the correct electrical connection procedures.
figure | Ground | |
Receptacle | ||
| ||
| *Opening for | |
| Power Cord |
IMPORTANT: * Power cord opening for metal cabinets: Deburr opening to remove rough edges.
Radio or TV Interference
Should there be any interference caused by the
E2