Operating Your Breville Product

OPERATING

your Breville Product

BEFORE FIRST USE

Remove any promotional material attached to your kettle. It is recommended that before ﬁrst use, the kettle is ﬁlled to the maximum level with cold tap water then boiled. Discard the water. Your kettle will only operate when positioned on the power base with the ‘On/Off’ switch in the ‘On’ position. The kettle will automatically switch off once the water has boiled.

The kettle will automatically switch ‘Off’ once the water has boiled. Lift the kettle from the power base and pour the water.

Take care to hold the kettle level, especially when ﬁlled to the maximum level. To re-boil it may be necessary to wait for a few seconds to allow the control to reset.

If further heating of the kettle is not required, unplug the power cord and empty the water from the kettle. Replace the kettle onto the power base and close the lid.

OPERATION OF YOUR KETTLE

To ﬁll the kettle, remove it from the power base and open the lid by pressing the lid release button. Fill with the desired amount of water.

NOTE

Always ﬁll the kettle between the minimum (MIN) and maximum (MAX) marks on the water window. Too little water will result in the kettle switching ‘Off’ before the water has boiled. Filling above maximum (MAX) mark may result in boiling water splashing from the kettle.

Close the lid, ensuring it is locked ﬁrmly into place. Position the kettle securely onto the power base and insert the power plug into a 110/120V power outlet.

Press the ‘On/Off’ switch to the ‘On’ position for water to boil.

NOTE

To operate correctly, the kettle should always be used with the scale ﬁlter ﬁrmly in place.

NOTE

This kettle must only be used with the power base supplied. Use caution when pouring water from your kettle, as boiling water will scald. Do not pour the water too quickly.

SAFETY BOIL DRY PROTECTION

The kettle is ﬁtted with a safety device which protects against overheating should the kettle be operated with insufﬁcient water. If this occurs, the kettle will stop heating. Allow kettle to cool before reﬁlling. Remove the kettle from the power base and add water. Return the kettle to the power base. The safety device will then automatically reset.

For additional safety, your kettle is ﬁtted with an additional thermal cut out. In the event of overheating, the kettle will automatically shut down to prevent further damage. Should this occur, contact Breville Consumer Service.

WARNING

This appliance is designed for boiling drinking quality water only. Never use to heat or boil any other liquids or foodstuffs. The lid should always be ﬁrmly in place and locked into the closed position before use.

WARNING

Do not press the lid release button on the handle to open the lid during operation. This may result in boiling water splashing from the kettle. Pour out all the hot water from the kettle before opening the lid to reﬁll.