Operating your Breville Aroma Style Coffee Maker

Operating your Breville Aroma Style Coffee Maker

Before first use

Before brewing your coffee for the very first time, clean the Aroma Style Electronic Coffee Maker thoroughly as follows:

1.Lift the water tank lid and fill the water tank with cold water to the maximum mark.

2.Insert plug into a 230/240V power outlet and then switch on at the outlet.

3.Ensure the filter holder is firmly positioned into place. Close the water tank lid.

4.Position the empty carafe, with the lid on, onto the hot plate and switch the Coffee Maker on. The light above the on/off button will illuminate and the water will start to drip through.

5.When the water has dripped through, press the on/off button to switch the Coffee Maker off. Remove the carafe from the hot plate, empty and wash in hot soapy water. Rinse and dry thoroughly.

The Aroma Style Electronic Coffee Maker is now ready for use.

Permanent stainless steel mesh filter basket

This filter basket is provided to ensure optimal flavour extraction from the finely ground coffee into the brewed coffee.

The filter basket is removable and should be washed in warm, soapy water after each use, then rinsed and dried thoroughly. Replace back

Setting the clock to the time of day on the LCD

The clock does not have to be set to the time of day for the manual operation of the Coffee Maker

The clock has to be set for time of day for the automatic operation of the Coffee Maker.

Note

To set the clock to the time of day:

1.When the Coffee Maker is plugged in and switched on at the power outlet the LCD will flash 12:00 and the AM icon in the top left hand corner.

2.Press the ’HOUR‘ button to select the current hour time. Press and hold the ’HOUR‘ button to scroll through numbers quickly. When the number displayed approaches the desired setting, press and release the button to advance one digit at a time. (AM is indicated in the upper left hand corner of the clock display and PM in the lower left hand corner).

3.Press the ’MIN‘ button to select the current minute time. Press and hold the ’MIN‘ button to scroll through numbers quickly. When the number displayed approaches the desired setting, press and release the button to advance one digit at a time.

Brewing coffee – manual operation

1. Lift the water tank lid and fill the water tank

with cold water. The number of cups is shown

by the water level indicator. Do not exceed the

maximum fill level. It is recommended not to

2.Insert plug into a 230/240V power outlet and then switch on at the outlet.

3.Ensure the filter holder is firmly positioned into place. Insert the stainless steel mesh filter basket into the filter holder.

4.Spoon ground coffee into the stainless steel mesh filter basket. Allow approximately 1 heaped teaspoon of ground coffee for each cup of brewed coffee. Close the water tank lid.

5.Position the empty carafe, with the lid on, onto the hot plate.

6.Press the on/off button to switch the Coffee Maker on. The light above the on/off button will illuminate and the coffee will start to drip through.

While the non-drip feature is a convenient way to pour a cup of coffee mid-cycle, we recommend you wait until the completion of the brew cycle, as the strength and flavour of the coffee poured mid-cycle will vary from the finished brew.

While this temporarily stops the coffee from dripping into the carafe, it does not stop the brewing cycle. After pouring a cup of coffee, the carafe should immediately be returned to the hot plate for completion of the brewing cycle and to prevent the filter basket from over flowing.

Note

7.The non-drip valve feature allows you to interrupt the brewing cycle before the entire carafe has finished filling.

8.When the brewing process ends and the water tank level indicator is on empty, there will still be hot liquid in the filter basket. Wait a few minutes for the rest of the liquid to drip through into the carafe.

9.After the coffee grounds have cooled, open the water tank lid and carefully remove the mesh filter basket by grasping the handle, and lifting straight up from the filter basket holder.

10.The hot plate will keep the coffee hot for two hours as long as the Coffee Maker is switched on.

11.Always switch the Coffee Maker off when the carafe is empty or when you no longer want to keep the coffee hot.

If you wish to brew another carafe of coffee immediately, press the on/off button to off, switch off at the power outlet and unplug, clean the carafe and the stainless steel mesh filter basket, then follow the steps under ‘Brewing coffee’.

Note

into the filter holder.

Disposable paper coffee filters are not necessary and should not be used with or without the permanent stainless steel mesh filter basket.

Note

make less than 4 cups.

There are two drip holes on the back of the water tank to prevent exceeding the capacity of the Coffee Maker. If too much water is added it will flow from these holes down the back of the Coffee Maker.

Note

TO AVOID THE FILTER BASKET OVERFLOWING, THE CARAFE MUST FIT SECURELY INTO THE COFFEE MAKER HOT PLATE, WITH THE LID ON AT ALL TIMES. IF NOT PROPERLY POSITIONED ON THE HOT PLATE, HOT WATER OR HOT COFFEE MAY OVERFLOW.

DO NOT OPEN THE WATER TANK LID DURING THE BREWING CYCLE AS HOT STEAM COULD CAUSE INJURY. IF WATER/COFFEE IS NOT DRIPPING FROM THE COFFEE MAKER, IMMEDIATELY PRESS THE ON/OFF BUTTON, SWITCH OFF AT THE POWER OUTLET, UNPLUG AND WAIT 10 MINUTES BEFORE OPENING THE WATER TANK LID AND CHECKING THE FILTER BASKET.

THE COFFEE MAKER BECOMES VERY HOT DURING THE BREWING CYCLE. PLEASE HANDLE WITH EXTREME CARE.

BCM600 specifications

The Breville BCM600 is an innovative and thoughtfully designed coffee maker that caters to the needs of coffee enthusiasts and casual drinkers alike. With a sleek and modern appearance, it combines functionality with aesthetic appeal, making it a stylish addition to any kitchen countertop.

One of the standout features of the BCM600 is its advanced brewing technology. This machine utilizes a patented Brewing System that delivers optimal water temperature and extraction time. This ensures that every cup of coffee maximizes flavor and aroma, allowing users to enjoy a rich and satisfying brew with every sip. The precision temperature control system maintains the ideal brewing conditions for different types of coffee, whether it be a bold espresso or a smooth drip coffee.

Another notable characteristic of the Breville BCM600 is its user-friendly interface and customization options. The machine comes equipped with simple controls and an easy-to-read LCD display, allowing users to select their preferred strength and brew size effortlessly. The ability to customize these settings ensures a personalized experience for each user, catering to individual taste preferences.

In terms of build quality, the BCM600 is constructed from durable materials designed to withstand daily use. The machine features a stainless-steel housing that not only enhances its aesthetic appeal but also contributes to its longevity. The easy-to-clean components, including a removable water tank and drip tray, make maintenance hassle-free, allowing users to enjoy their coffee without the worry of complex cleaning processes.

The BCM600 also features a built-in grinder, which allows users to enjoy the freshest coffee possible. By grinding whole beans just before brewing, the machine retains the natural oils and flavors that can often be lost in pre-ground coffee. The grinder is adjustable, providing varied grind sizes to suit different brewing preferences and methods.

For those who enjoy convenience, the BCM600 incorporates a programmable timer, allowing users to set their machine to brew coffee at a specific time. This feature is particularly useful for busy mornings when every minute counts.

Overall, the Breville BCM600 exemplifies a perfect blend of innovative technology, user convenience, and appealing design. Whether you're a coffee connoisseur or simply enjoy a good cup of joe, this coffee maker is sure to elevate your coffee experience.