Dolby Laboratories CD Player manual To Install Batteries 1. Openthe batterydoor

RECORDING FROM THE CD PLAYER

~;I

;1

TO STOP RECORDING

Press the STOP/EJECT button of Deck A.

TO INTERRUPT RECORDING

Press the PAUSE button of Deck A.

To resume recording; press the PAUSE button again.

	i
	t
	~
	~
	.
	:t:
TO ERASE A RECORDED TAPE	"
1) Press the FUNCTION button to TAPE.
	i
2) Insert a tape with the side you want to erase facing	~
you.
3) Press the RECORD button to start erasing.
	I
	I

1

!1

REMOTE CONTROL
1)	SPEAKERS	RESET	button		11)	MEMORYbutton
2)	SLEEPbutton				12)	OPEN/CLOSE button
3)	BALANCE	UR, SPEAKER		'+'1'.'buttons	13)	BANDbutton
4)	FUNCTION	button			14)	PRESETEQbutton
5)	TUNINGUPIDOWNIREPEATIRANDOM				15)	X-BASSbutton
	buttons				16)	PRO LOGIC button
6)	DOLBY 3 STEREO		button		17)	VOLUMEcontrolbuttons
7)	SKIPISEARCI-VPRESET			buttons	18)	PlAY/PAUSEbutton
8)	STOP button				19)	POWEFI/STANDBY
9)	TIMERbutton					button
10)	TESTbutton				20)	DISC SKIP button

USING THE REMOTE CONTROL CORRECTL y

.Point the Remote Control at the REMOTE SENSOR located on the unit.

.When there isa strong ambient light source, the performance of the infrared REMOTE SENSOR may be degraded, causing unreliable operation.

.The recommended effective distance for remote operation is about 6 meters(19feet).

TO INSTALL BATTERIES 1. Openthe batterydoor.

2.Insert two RO3 (MA or UM-4) size batteries.

BATTERY REPLACEMENT

When batteries become weak, the operating distance of the Remote Control is greatly reduced and you will need to replace the batteries.

NOTE:

If the Remote Control is not going to be used for a long time, remove the batteries to avoid damage caused by battery leakage corrosion.

E-21