KitchenAid KPEC992M installation instructions Use and Care Information, Operation

Use and Care Information

WARNING — TO REDUCE THE	WARNING — TO REDUCE THE	SMOTHER FLAMES with a close-
RISK OF FIRE, ELECTRIC	RISK OF A RANGE TOP GREASE	fitting lid, cookie sheet, or metal
SHOCK, OR INJURY TO	FIRE:	tray, then turn off the burner. BE
PERSONS, OBSERVE THE	Never leave surface units	CAREFUL TO PREVENT BURNS. If
FOLLOWING:		the flames do not go out
	unattended at high settings.
Use this unit only in the manner	Boilovers cause smoking and	immediately, EVACUATE AND
intended by the manufacturer. If	greasy spillovers that may ignite.	CALL THE FIRE DEPARTMENT.
	Heat oils slowly on low or	NEVER PICK UP A FLAMING PAN
you have questions, contact the
	medium settings.
manufacturer. Before servicing		— You may be burned.
	Always turn hood ON when
or cleaning unit, switch power		DO NOT USE WATER, including
off at service panel and lock	cooking at high heat or when
		wet dishcloths or towels — a
switch power off at service	cooking flaming foods.
		violent steam explosion will
panel and lock service panel to	Clean ventilating fans frequently.
		result. Use an extinguisher
prevent power from being	Grease should not be allowed to	ONLY if:
switched on accidentally. When	accumulate on fan or filter.	You know you have a Class ABC
the service disconnecting means	Use proper pan size. Always use
		extinguisher, and you already
cannot be locked, securely
	cookware appropriate for the size
		know how to operate it.
fasten a prominent warning
	of the surface element.
device such as a tag to the	WARNING — TO REDUCE THE	The fire is small and contained in
service panel.		the area where it is started.
	RISK OF INJURY TO PERSONS IN
CAUTION: For general		The fire department is being
	THE EVENT OF A RANGE TOP
ventilating use only. Do not use	GREASE FIRE, OBSERVE THE	called.
to exhaust hazardous or	FOLLOWING:	You can fight the fire with your
explosive materials and vapors.
		back to an exit.

Replacing the Halogen lamps:

The hood liner uses 12-volt, 20 watt halogen lamp bulbs.

Before you begin, make sure that the range hood is turned off and that the lamps have had sufficient time to cool.

To replace a halogen lamp:

• Remove 2 screws from the

Operation

The hood liner is designed to remove smoke, cooking vapors and odors from the cooktop area.

For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from cooking area.

blower speed

blower will begin operating at the speed set on the speed switch.

OFF: Move the blower switch to the “0” position.

Adjusting the exterior blower speed:

Adjusting exterior blower motor speed:

Move speed control switch to vary the blower speed from low (at the left) to high (at the right). The exterior blower motor will operate at the speed set when the motor is turned on.

circular metal trim around the

lamp assembly.

• Pull the trim with the lamp

blower motor

light switch switch

switch

assembly attached down far

enough so that the lamp can be

pushed out of the socket clips.

• Insert the new lamp into the

socket clips and push the lamp

and trim assembly back up into

the hood.

• Replace the screws.

Operating the lights:

ON: Move the light switch to the “1” position.

OFF: Move the light switch to the “0” position.

Operating the exterior blower motor:

ON: Move the blower motor switch to the “1” position. The

6