Setting Up
Connect the speakers
Connect the cube arrays to the Powered Acoustimass® module, and then connect the module to your receiver. The supplied cables make this easy. The cables may be separated or “unzipped” as much as needed to comfortably reach the speakers. See Figure 4.
Figure 4
Separating cables
CAUTION: Before making any connections turn off your receiver and unplug it from the outlet (AC power mains). Not doing so may result in damage to your system.
CAUTION: Never connect the cubes directly to a receiver output. Always connect the cube arrays to the Powered Acoustimass module, then connect the module to the receiver.
CAUTION: Never use broken or frayed wiring, which can result in electrical shock or damage to your system. The supplied cables are not intended for
Connect the Powered Acoustimass module to the center and front cube arrays
Three individual 20 (6m) foot wire pairs connect the Powered Acoustimass module to the Center, Right, and Left front cube arrays. Each cable connects to the module with a single plug.
1.Connect the wire pair marked C to the center speaker. Just press the terminal tab on the back of the cube array to insert the marked wire into the red terminal and the plain wire into the black terminal. See Figure 5. Release the tab to secure the wires.
2.Connect the wire pair marked R to the right front speaker (to the right of the TV as you face it).
3.Connect the wire pair marked L to the left front speaker.
Figure 5
Making cube speaker connec- tions
Marked wire
to Red terminal
AM194452_06_V.pdf | October 22, 2001 | 7 |