KitchenAid dimensions Freestanding and Slide-In Dual Fuel Range, KDRS807S KDSS907S

® 30" Freestanding and Slide-In Dual Fuel Range

PRODUCT MODEL NUMBERS

OVERALL DIMENSIONS

KDRS807S KDSS907S

Freestanding Range

Slide-in Range

Gas supply: Use 3/4" (1.9 cm) rigid pipe gas supply line to the range location. A smaller size pipe on long runs may result in insufficient gas supply. With L.P. gas, piping or tubing size can be 1/2" (1.3 cm) minimum. If local codes permit, it is recommended that new flexible metal tubing, design-certified by CSA, 4-5 feet (122-152.4 cm) long, 1/2" (1.3 cm) or 3/4"

(1.9 cm) I.D., be used for connecting the range to the rigid gas supply line. A 1/2" (1.3 cm) male pipe thread is needed for connection to pressure regulator female pipe threads. An easily accessible individual manual shutoff valve must be located in the same room, but external to the range.

Electrical: When a 4-wire or 3-wire, single phase 120/240 volt, 60 Hz, AC only electrical supply is available, a 50-amp maximum circuit protection is required. When a 4-wire or 3-wire single phase 120/208 volt 60 Hz, AC only electrical supply is available, a 40-amp

B

A

C

D*

E

F**

A. 5³⁄₄" (14.6 cm)	E. Model/serial number plate
B. 30" (76.2 cm)	(located on the right-hand
C. 41³⁄₄" (106 cm) overall height	side oven door trim)
	F. 27¹⁄₄" (69.2 cm) max. from
with leveling legs screwed all
the way in.	handle to standoff at back
D. 36" (91.4 cm) cooktop trim	of range**
height with leveling legs
screwed all the way in*

A

F

E**

A.30⁹⁄₁₆" (77.6 cm)

B.35⁵⁄₈" (90.5 cm) height to underside of cooktop edge with leveling legs screwed all the way in*

C.Model/serial number plate (located on the right-hand side oven door trim)

B*

C

D

D30" (76.2 cm)

E. 27¼" (69.2 cm) from handle to standoff at back of range**

F.23" (58.4 cm) countertop notch to rear of cooktop

maximum circuit protection is required, fused on both sides of the line. A separate circuit is recommended. A time-delay fuse or circuit breaker is recommended.

*Range can be raised approximately 1" (2.5 cm) by adjusting	*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.	the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)	**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 1" (2.5 cm) beyond	countertop; front of oven door protrudes 1³⁄₄" (4.4 cm) beyond
24" (61 cm) base cabinet.	24" (61 cm) base cabinet.

SLIDE-IN RANGE COUNTERTOP PREPARATION

The cooktop sides of the slide-in range fit over the cutout edge of your countertop.

If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required.

Formed front-edged countertops must have molded edge shaved flat 3/8" (1.0 cm) from each front corner of opening.

Tile countertops may need trim cut back

3/8" (1.0 cm) from each front corner and/or rounded edge flattened.

If countertop opening width is greater than 30" (76.2 cm), adjust the 3/8" (1.0 cm) dimension.

Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Range must be level for satisfactory baking conditions.

30"

(76.2 cm)³⁄₈"

(1.0 cm)

30 ³⁄₄"

(78.1 cm)

CABINET OPENING DIMENSIONS

	13" (33 cm) upper	For minimum					13" (33 cm) max.			For minimum
		clearance to top								clearance to top
	cabinet depth	of the cooktop,				upper cabinet depth				of the cooktop,
	30" (76.2 cm) min.	see NOTE.					30" (76.2 cm) min.			see NOTE.
	opening width							opening width
18" (45.7 cm)				18" (45.7 cm)					22¹⁵⁄₁₆" (58.3 cm)
								¾" (1.9 cm)	opening depth
	30" (76.2 cm)			upper cabinet
upper cabinet
	min. opening			to countertop			radius both corners
to countertop
	width							30" (76.2 cm)
	Grounded							min. opening
								width
	outlet
									Grounded
		This shaded area	Cabinet door	5" (12.7 cm) min.				8"	outlet		Cabinet door
	8"								This shaded area		or hinge
			or hinge
5" (12.7 cm) min.	(20.3 cm)	recommended for		clearance from				(20.3 cm) recommended for			should not
clearance from		installation of	should not	both sides of the					installation of		extend into
		outlet or	extend into			8"
both sides of the	8"			range to the side					outlet or		the cutout.
		junction box.	the cutout.		(20.3 cm)
range to the side (20.3 cm)				wall or other					junction box.
							7" (17.8 cm)
wall or other	7" (17.8 cm)	4¹⁄2"		combustible					4¹⁄2"
combustible				material.
									(11.4 cm)
material.		(11.4 cm)
				This shaded area
Available area				recommended for				Available area
for gas and electric	1¹⁄2" (3.8 cm)			installation of				1¹⁄2"	for gas and
								(3.8 cm)
installation.	This shaded area			rigid gas pipe.					electric
				4¹⁄2"					installation.
	recommended for
4¹⁄2"				(11.4 cm)
	installation of
(11.4 cm)	rigid gas pipe.

NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet is protected by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or

0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. 9763462
Instructions packed with product. Specifications subject to change without notice.	03-19-07