Philips Double Oven Product dimensions, Cutout dimensions, Tool needed, Parts supplied

Product dimensions Before you start...

Single oven	Double oven
	28-3/8"
28-3/8"	(72.1 cm) max.
	recessed width
(72.1 cm) max.
recessed width

27-1/2"	29"
	(73.7 cm)
(69.9 cm)	max.	51"
recessed	overall
height	height	(129.5 cm)
		max.
	49-1/2"	overall
		height
	(125.7 cm)
	recessed
	height
23"	29-3/4" (75.6 cm)
(58.4 cm)
	overall width
max.
recessed

29-3/4" (75.6 cm)

23"

overall width

(58.4 cm)

max.

recessed

depth

Cutout dimensions

30" (76.2 cm)

min. cabinet

30" (76.2 cm) min.

cabinet width

1" (2.5 cm) top

of cutout to

bottom of upper

cabinet door

1-1/2"

(3.8 cm) min.

27-3/4"

top of cutout

(70.5 cm)

to underside

min.

of countertop

cutout

height

49-3/4"

(126.4 cm)

28-1/2"

min.

(72.4 cm)

cutout

cutout

height

width

28-1/2"

(72.4 cm)

5-1/4" (13.3 cm)

cutout width

bottom of cutout

to floor

Single oven

undercounter

1-1/2" (3.8 cm)

14-

3/4"

(37.5 cm)

(without cooktop

min. bottom of

bottom

installed above)

cutout to top of

of cutout

cabinet door

to floor

	23-1/4"			Double oven
	(59.1 cm) min.
	cutout depth
	23" (58.4 cm)
	recessed oven			30" (76.2 cm) min.
	depth
				cabinet width
				1" (2.5 cm) top
				of cutout to
				bottom of upper
cabinet	recessed	oven		cabinet door
	oven	front
			27-3/4"	28-1/2"
			(70.5 cm)
				(72.4 cm)
			min.
				cutout
	Cabinet side view		cutout
				width
			height

Cabinet filler kits are available from your dealer. Use a matching color kit if oven is smaller than your cabinet opening.

Single oven filler height is 3-5/16" (8.4 cm)		1-1/2"		32"
		(3.8 cm)
Black	— 4378941				(81.3 cm)
		min.
				bottom of
White	— 4378942	bottom of
					cutout to
Almond — 4378943		cutout to			floor
		top of
Double oven filler height is 6-5/16" (16 cm)		cabinet
		door
Black	— 4378947
White	— 4378948		Single oven
Almond — 4378949

Your safety and the safety of others are

very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”. These words mean:

DANGER

You can be killed or seriously injured if you don’t immediately follow instructions.

WARNING

You can be killed or seriously injured if you don’t follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

Important: Observe all governing codes and ordinances.

Proper installation is your responsibility. Have a qualified technician install this oven.

Oven location should be away from strong draft areas, such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance.

Recessed installation area must provide complete enclosure around the recessed portion of the oven.

Electrical ground is required. See “Electrical requirements.”

Electrical supply junction box should be located 3 inches (7.6 cm) maximum below the support surface when oven is installed in a wall cabinet. Drill a 1-inch minimum (2.5 cm) diameter hole in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If installing the junction box on rear wall behind oven, junction box must be recessed and located in the upper or lower right or left corner of cabinet.

It is the customer’s responsibility:

To contact a qualified electrical installer.

To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 — latest latest edition*, or Canadian Electrical Code, C22.1-1982 and C22.2 No. 01982 (or latest edition)** and all local codes and ordinances.

Copies of the standards listed may be obtained from:

*National Fire Protection Association Batterymarch Park

Quincy, Massachusetts 02269

**CSA International

8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575

Tool needed:

Phillips screwdriver

Parts supplied:

4 screws (double oven)

Page 1