|
|
|
English |
| 7 |
|
|
|
SYNCHRONIZED
NORMAL SPEED
•Insert a fully rewound prerecorded cassette into Tape Deck B.
•Insert a fully rewound blank cassette tape into Tape Deck A.
•Set the Function Selector to the TAPE position and keep the DUBBING Selector in the “high” position.
•Press the Pause Key of Tape Deck “A”, and then press both the Play and Record keys of Tape Deck “A”.
•Press the Play Key of Tape Deck “B”. The contents of the tape in Deck “B” will now be copied onto the tape in Deck “A”.
•Adjust the Volume Control to the desired levels for monitoring purposes. The recording will be unaffected by changes in these control.
•To stop recording, press both of the Stop / Eject Keys. Otherwise the tape will stop automatically when the end of the tape is reached.
HIGH SPEED TAPE-TO-TAPE RECORDING
•Press down the DUBBING Button to the “low” position.
•Follow the steps described above for Normal Speed
the sound.
NOTES: If the length of the tape in Deck B is shorter than that in Deck A, the Play Key of Deck
Bwill be released automatically at the end of the tape. Tape A will continue to record until the tape reaches its end, or its Stop / Eject key is pressed.
If the length of the tape in Deck A is shorter than that in Deck B. The Record and Play Keys of Deck A will be released automatically at the end of tape. Tape B will continue to play back until the tape reaches its end, or its Stop / Eject Key is pressed.
SOUND ADJUSTMENT
•Press the PRESET EQ button to select between
•To Mute the sound instantly press the MUTE Button on the Remote control.
The MUTE indicator lights up . Pressing this button again or pressing the VOLUME buttons on the remote Control, will switch the sound on again.
HANDLING COMPACT DISC
8English
•To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully by the edges.
•Fingerprints and dust should be carefully wiped off the disc’s recorded surface with a soft cloth. Unlike conventional records, compact discs have no grooves to collect dust and microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in a straight line from the inside to the outside of the disc. Small dust particles and light stains will have absolutely no effect on reproduction quality.
•Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to clean compact discs. These chemicals can irreparably damage the disc’s surface.
•Discs should be returned to their cases after use. This avoids serious scratches that could cause the Laser pickup to skip.
•Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods. Long exposure to high temperatures can warp the disc.
•Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
COMPACT DISC OPERATION
LOADINGAND UNLOADING COMPACT DISCS
•Press the STANDBY Button to ON . The Standby indicator will go off.
•Set the Function Selector to the CD position.
•Press the OPEN/CLOSE button to open the CD drawer.
Note: You do not have to wait for the changer to search all three pockets for Ds. You may open the CD drawer immediately.
•The CD pockets are numbered “1,2 and 3”. These numbers correspond to the disc indicators in the CD display. The disc indicators do not change position. However the disc symbol will flash to show which disc is in the play position.
Place up to 3 CDs in the pockets of the tray. Place the disc you want to play first in pocket no. 1. Place the disc you want to play second in pocket no.2 and so on. To load three CDs in the tray it will be necessary to rotate the tray to expose the third pocket. After you load the first two discs press the Disc Skip button to rotate the tray and then load your