KitchenAid® Single Drawer Dishwasher Custom Cabinet Requirements
19 7⁄8” | Utility Hole: |
| NOTE: Diamond | |
(50.5 cm) | 1 1⁄2” (3.8 cm) dia. | 16 7⁄32” | symbol | indicates |
| either side immediately | (41.2 cm) | Side Attaching Tab | |
| screw locations. | |||
3 13⁄16” | adjacent to corner |
| ||
|
|
| ||
|
|
|
| |
(9.7 cm) |
|
|
|
|
2 5⁄8” |
|
|
|
|
(6.7 cm) | 22 7⁄8 ” |
|
|
|
| (58.0 cm) |
|
|
|
| 23 5⁄8” (60.0 cm) |
|
|
|
| The minimum thickness of cabinet |
|
|
|
| cavity sides and bottom is 5⁄8” (1.6 cm) |
|
| |
FIGURE 2
IMPORTANT: For best results, carefully read the following instructions and recommendations before building the custom cabinet.
•Build the custom cabinet to the size and specifications as shown (See figure 2).
•The minimum thickness of cabinet/cavity sides is 5⁄8” (1.6 cm).
•The supporting base of the cabinet must be solid, level, and able to sustain weight up to 104 lbs. (47 kg).
•For best installation, the use of all four Side Attaching Tabs is recommended. Wood spacers may need to be added to the sides of the cabinet in order to properly secure the dishwasher to the cabinet.
•A utility hole, that will be used to route power supply cord and hoses, must be located as shown (See figure 2). The utility hole can be located on either side depending on the location of services. If the utility hole is not located as shown, the hoses will prevent the dishwasher from being pushed back all the way into the cavity. Make sure the edges of the utility hole are smooth or covered to prevent damage to the power cord and hoses. If the utility hole is through a metal cabinet, the hole must be protected with an edge protector.
•A
6” (15.2 cm) to 18” (45.7 cm) to either side of the utility hole in the cabinet sidewall. The power outlet must be accessible after installation.
•When installing a custom wood front door panel to the dishwasher, the cabinet width of 23 5⁄8” (60.0 cm) must be increased to allow 3⁄32” (2.5 mm) clearance between the cabinet side and custom panel edge (See figure 2).
•For corner installation, there must be a 1⁄2” (12.7 mm) space between the adjacent cabinet doors (i.e. door knobs) and open dishwasher drawer.
Adjacent cabinetry must not extend above the cavity base.
DISHWASHER
•It is recommended that wood cabinetry surrounding the dishwasher be sealed with an
•Refer to the Installation Instructions Single Drawer Dishwasher included with the Drawer Dishwasher to complete installation.