3.Remove surface burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light.
Place burner grates over burners and caps.
B
A
C
Complete Installation
Electronic Ignition System
Initial lighting and gas flame adjustments
Surface burners use electronic igniters in place of standing pilots. When the cooktop control knob is pushed in and turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is pushed in and turned to “LITE.”
A. Igniter electrode
B. Burner cap
C. Burner base
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
4.Plug into a grounded 3 prong outlet.
Attach Cooktop to Countertop
NOTE: This section applies only if you are using clamping brackets.
F
A
B
E
D
C
A. Glass cooktop | D. Clamping bracket (extends far | |
B. Cooktop base | enough beyond cooktop base | |
C. Attachment screw | to allow installation of | |
clamping screws) | ||
| ||
| E. 2½" (6.4 cm) clamping screw |
F.Countertop
1.Place the 2½" (6.4 cm) clamping screws into the brackets.
2.Check that the cooktop is still level.
3.Use a
Check Operation of Surface Burners
1.Push in and turn the surface burners control knobs to the “LITE” position.
The surface burner flame should light within 4 seconds. The first time a surface burner is lit it may take longer than
10 seconds to light because of air in the gas line.
2.Check the flame on HI for a blue color. It should be clean and soft in character. No yellow tip, blowing or lifting of flame should occur. Occasional orange flashes are normal and reflect different elements in the air or gas.
3.Repeat at LO position.
4.After verifying the proper burner operation, turn the control knobs to OFF.
If burners do not light properly:
■Turn surface burner control knob to the OFF position.
■Check that the power supply cord is plugged in and the circuit breaker has not tripped or the fuse blown.
■Check that the gas shutoff valves are set to the “open” position.
■Check that burner caps are properly positioned on burner bases.
Recheck operation of surface burners. If a burner does not light at this point, turn control knobs to Off and contact your dealer or authorized service company for assistance.
Adjust Flame Height
The surface burner “low” flame should be a steady blue flame approximately ¼" (0.64 cm) high.
A
B
A.Low flame
B.High flame
8