Dual DA304 Master/Slave Mode cont, Installation, MINIMUM IMPEDANCE MUST NOT BE LOWER THAN 2 OHMS

Page 11
Master/Slave Mode (cont.)

INSTALLATION

Master/Slave Mode (cont.)

*MASTER

For master amplifier, set the switch to master. This will route the signal through Line-out to the slave amplifier. Set the phase to 0, all adjustments for gain and sound are done on this amplifier. The remote subwoofer control should be connected to master amplifier as well.

*SLAVE

For slave amplifier, set the switch to slave and phase to 180. Connect the Line-out of master amplifier to input on this amplifier. All adjustments should be set to minimum.

Connect Data-Link plug from master to slave amplifier. For speaker connection, the positive

(+)of the speaker connects to positive (+) of master and negative (-) of the speaker connects to positive (+) of slave amplifier. Connect both negatives (-) of master and slave each other.

NOTE: FOR BEST PERFORMANCE, USE WIRE 12 AWG OR THICKER FOR THE NEGATIVE TO NEGATIVE CONNECTION.

*MINIMUM IMPEDANCE MUST NOT BE LOWER THAN 2 OHMS

11

Image 11
Contents DA304 DA602 DA604 DA904 DA4001 DA6001 DA8001 Mobile Power AmplifiersPERFORMANCE SERIES Mounting Location INSTALLATIONPreparation Before You StartGround Wire GND Connection DescriptionsINSTALLATION Power Wire +12VAudio Inputs and Controls INSTALLATIONDA304 Power and Speaker ConnectionsINSTALLATION DA602DA6001 INSTALLATIONAudio Inputs and Controls DA4001Speaker Connections Power and Speaker ConnectionsINSTALLATION Main Power Connections Typical Wire RoutingINSTALLATION Power/Ground Wire SizeHigh Level Input Speaker Wire Amplifier ConnectionsINSTALLATION Input Signal Connections Low Level Input RCAINSTALLATION Master/Slave ModeSLAVE Master/Slave Mode contINSTALLATION MASTERInput level Control Crossover Mode Configuration/SetupINSTALLATION LED Indicatorsindicator TroubleshootingINSTALLATION ProblemDA904 SpecificationsINSTALLATION DA4001 SpecificationsINSTALLATION What to do? One Year Limited Warranty