Hotpoint HXB9LSX manual General Safety, Electrical Connection, AIR Vent, Filtering or Ducting ?

Page 10

English

The hood can look different to that illustrated in the drawings in this EN booklet. The instructions for use, maintenance and installation, however,

remain the same.

Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The extractor hood has been designed exclusively for domestic use.

!It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure it is together with the product.

!Read the instructions carefully: there is important information about installation, use and safety.

!Do not carry out electrical or mechanical variations on the product or on the discharge conduits.

GENERAL SAFETY

The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.

Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.

WARNING! Do not connect the appliance to the mains until the installation is fully complete.

Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply.

Always wear work gloves for all installation and maintenance operations.

The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety.

This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance.

This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance.

Never use the hood without effectively mounted grating!

The hood must NEVER be used as a support surface unless specifically indicated.

The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels.

The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels.

The flaming of foods beneath the hood itself is severely prohibited.

The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances.

Any frying must be done with care in order to make sure that the oil does not overheat and ignite.

Accessible parts of the hood may became hot when used with cooking appliance.

With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.

The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).

This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires.

Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.

We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-observance of the instructions included in this manual.

ELECTRICAL CONNECTION

The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions.

Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled.

Replacing the power cable

The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.

AIR VENT

(for the suction versions)

Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange).

Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise.

Any responsibility in the matter is therefore declined.

!Use a duct of the minimum indispensible length.

!Use a duct with as few elbows as possible (maximum elbow angle: 90°).

!Avoid drastic changes in the duct cross-section.

!Use a duct with an as smooth as possible inside.

!The duct must be made of certified material.

!The company declines any responsibility whenever these regulations are not respected.

FILTERING OR DUCTING ?

!Your cooker hood is ready to be used in suction version.

To use the hood in filtering version the special ACCESSORY KIT must be installed.

Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately.

Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood.

Information about the conversion of the hood from suction version to filtering version is present in this manual.

Ducting version

In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Attention! The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting pipe must be equal to that of the connection ring.

In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. Attention! If the hood is supplied with active charcoal filter, then it must be removed.

Filter version

One active charcoal filter is needed for this and can be obtained from your usual retailer.

The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid.

10

Image 10
Contents Instructions for use Page Page Page Page Page Page Page Page AIR Vent General SafetyElectrical Connection Filtering or Ducting ?Controls T1. ON/OFF Lights T2. Speed decreaseMaintenance Manual calibration of the sensorDisposal Technical DataMalfunctions Page Page LIB0022493

HXB9LSX specifications

The Hotpoint HXB9LSX is a modern refrigerator that seamlessly blends cutting-edge technology with sleek design, making it a must-have for any contemporary kitchen. This model stands out for its impressive capacity and energy efficiency, catering to the needs of families and individuals alike.

One of the most notable features of the HXB9LSX is its generous storage capacity. With ample space for groceries and perishables, it ensures that users can easily organize and access their food items. The adjustable shelves allow for flexible storage options, accommodating larger items with ease. The dedicated compartments also enhance organization, making it simple to find what you need quickly.

The refrigerator incorporates advanced cooling technology, including the innovative No Frost system. This feature prevents the accumulation of ice and frost, eliminating the need for manual defrosting and ensuring optimal preservation of food. By maintaining a consistent temperature throughout the unit, No Frost also helps in prolonging the freshness of perishable items.

Energy efficiency is another hallmark of the Hotpoint HXB9LSX. Rated with an excellent energy efficiency rating, it significantly reduces energy consumption without compromising performance. This is not only beneficial for the environment but also translates into lower electricity bills for the user.

The HXB9LSX is equipped with an intelligent LED lighting system that brightens every corner of the fridge, making it easy to locate items even in dim lighting. The modern design of the refrigerator, featuring a stainless-steel finish, enhances any kitchen decor and provides an elegant touch.

Another impressive feature is the fast chill and fast freeze options. These functions allow users to rapidly cool down hot foods or freeze items quickly, ideal for preserving the texture and taste of fresh produce. The electronic control panel makes it easy to adjust settings and monitor the refrigerator’s performance effortlessly.

In terms of noise level, the Hotpoint HXB9LSX operates quietly, ensuring that it doesn’t disrupt the tranquility of your home. The durable construction and high-quality materials used in its design ensure longevity, making it a smart investment for any household.

Overall, the Hotpoint HXB9LSX combines practicality with modern technology, offering users a reliable and efficient refrigeration solution that enhances food storage and organization in the kitchen. Its standout features and user-friendly design make it a popular choice among consumers seeking a blend of functionality and style.