Disposing of the plug
Cut off and dispose of the supplied plug if it does not fit your socket. The cable should be cut as close as possible to the moulded plug.
Remove the fuse.
WARNING:
To avoid a shock hazard do not insert the discarded plug into a socket anywhere else.
Fitting a new plug
IMPORTANT:
WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE...
Green and Yellow | - Earth |
Blue | - Neutral |
Brown | - Live |
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
- Connect Green and Yellow wire to terminal marked
'E' or | or coloured Green and Yellow. |
-Connect Brown wire to terminal marked 'L' or coloured red or brown.
-Connect Blue wire to terminal marked 'N' or coloured Black or Blue.
If a 13amp plug (BS 1363) is used it must be
fitted with a 13amp fuse. A 15amp plug must be protected by a 15amp fuse, either in the plug or adaptor or at the distribution board.
If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.
CE Marking certifies that this appliance conforms to the following EEC directives :
Low Voltage Equipment - 73/23/EEC & 93/68 EEC Electromagnetic Compatibility 89/336/EEC, 92/31/EEC & 93/68/EEC
Connection of the water supply
To carry this out, use the kit provided which contains all the GB necessary elements for connection to the water supply.
To improve the performance of the Aqua Care, we recommend that you fit a tap with a filter on the pipe for the connection to the water system: in this way it will be possible to manually interrupt the water supply during long periods in which Aqua Care is not used.
!The water pressure inside the water system must be between 0.8 bar and 8 bar.
!The appliance must only be connected to a water supply suitable for drinking.
Aqua Care function
The refrigerator you have purchased is fitted with the Aqua Care system which, thanks to an advanced filter system with active carbons, provides your household with fresh, filtered water.
!To improve the system’s performance, we recommend that you follow the instructions contained in this manual and in the assembly diagram provided with the kit.
Starting Aqua Care
After connecting it to the water system, installing the filter (see Replacing Aqua Care filter) and switching on the refrigerator (See Starting the appliance), it is necessary to remove any air from the Aqua Care system:
1. Activate the AQUA CARE function by pressing the correct button (see Control panel).
2. Place a container under the dispenser.
3.Hold the button down until the water is dispensed.
4. Drain and discard three litres of water.
!When using for the first time and each time the Aqua Care system is not used for more than 1 week, it will be necessary to drain and discard three litres of water.
3