Maintenance and care
Switching the appliance off
Replacing the light bulb
GB
During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply:
1.set the FREEZER OPERATION and APPLIANCE ON/ OFF Knob on Off
2.pull the plug out of the socket
!If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, it is sufficient to set the FREEZER OPERATION and APPLIANCE ON/OFF knob on the desired value. To disconnect the appliance, follow point 1 and 2.
Cleaning the appliance
•The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Do not use solvents, abrasive products, bleach or ammonia.
•The removable accessories may be soaked in warm water and soap or dishwashing liquid. Rinse and dry them carefully.
To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Follow the instructions below.
Access the light bulb (A) by unscrewing the fixing screw (B) which is located at the back of the lampcover, as shown (see diagram). Replace it with a similar light bulb, the power of which should not exceed 15W.
A |
B |
Avoiding mould and unpleasant odours
•The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly.
•If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open.
Defrosting the appliance
!Follow the instructions below.
Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair.
Defrosting the refrigerator compartment
The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a
special discharge outlet (see diagram) where the
heat produced by the compressor causes it to
evaporate. It is
necessary to clean the discharge hole regularly so that the water can flow out easily.
PURE WIND PLUS
Filter maintenance
Unhook the filters from the left side of the cover by inserting the tip of a small screwdriver into the gaps (see attached pictures).
Wash the filters regularly (every
9