Hotpoint WE26 manual Installation, Location and Power Connection

Installation

GB	! It is important that you keep this user guide handy so
	that you can refer to it at any time. Should you sell,
	give away, or move the wine cellar, please make sure
	that this user guide is with it.
	! Read this user guide thoroughly. It contains important
	information about how to use this wine cellar, how to
	install it, and how to operate it safely.
	! Should you need to move the wine cellar, keep it in a
	vertical position.

Location and Power Connection

Remove packaging

1. Immediately remove the packaging and check to make sure your wine cellar has not been damaged during transportation. If it is damaged, contact your Retailer immediately.

2. Carefully remove the packaging and stickers that protect the product. Open the door and check the components to make sure they are not damaged.

3. Take out the power cable.

Location

1. The wine cellar should be located in a well-ventilated, non-humid open area (do not place it in closets).

2. Place the wine cellar far away from any heat sources.

Power Connection

After transportation, let the wine cellar stand in its intended location for at least 3 hours before you plug it in. Before the power is connected, make sure of the following:

• the wall-outlet should be grounded (earthed) and it must meet the local electric code;

• the wall-outlet should be sufficiently rated to supply the wine cellar's maximum power consumption, indicated in the Technical Information on the right or on the wine cellar's data plate on the bottom right (see Product Description);

• the voltage should be as indicated in the Technical Information or on the wine cellar's data plate on the bottom right (see Product Description);

•the wall-outlet should be compatible with the wine cellar's plug. If not, replace the outlet or the plug. Do not use extension cords or power strips.

!Once installed, the power cord and the plug must be easy to access.

!The power cable should never be crushed or bent.

!The power cord should be regularly checked and, if necessary, replaced only by a qualified technician.

!The manufacturer cannot be held responsible if these procedures are not followed.

TECHNICAL INFORMATION

Model	WE26
Temperature	1 Zone
	Width cm 59
Measurements	Height cm 68
	Depth cm 56,2
Weight**	76 Kg
Weight	97 kg
Wattage	120 W
Energy Consumption	0,9 kWh / 24h
Voltage*	220 V
Frequency*	50 Hz

*These values will vary for each country. For specific product characteristics, check the wine cellar's data plate.

**When empty.

2