Hotpoint HXC9.8AT, HXC6.8AT manual Troubleshooting

Servicing the grease filter (A)
GB	The grease filter retains the
	particles of grease produced
	during cooking; it must be
	cleaned at least once a month
	with a non - aggressive
	detergent, either by hand or
A	with a low temperature, short
	dishwasher cycle.
	To extract the grease filter,
	pull the spring loaded handle.

If washed in a dishwasher, the metal filter may change colour, but this does not affect its performance.

Servicing the charcoal filter (B)

The charcoal filter retains unpleasant cooking odours. The filter saturates after a variable time, depending on the type of cooking and how often the grease filter is cleaned. The cartridge must be replaced at least once every twenty months.

This filter can NOT be washed or regenerated

	Disassembly: Remove the
	activated-carbon filter by
B	pressing the two front levers
	which secure it to the hood.

Electrical cable

If the power cable is damaged, it can be replaced by the manufacturer or his technical service, to prevent any attendant risks.

SCRAPPING

The unit is marked for conformity with European Directive 2012/19/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that the unit is scrapped properly, the user contributes to safeguarding the environment and public health.

The symbol on the product or on its accompanying documents indicates that the product may not be treated as domestic waste but must be handed over to a sorting centre for electrical and electronic waste. Dispose of it in accordance with local waste disposal regulations. For further information on the handling, recovery and recycling of this product, contact the local authority, domestic waste disposal service or the reseller from whom you purchased it

Troubleshooting

If something does not work, make the following simple checks before contacting Technical Service:

If the hood does not operate:

B

Assembly: Secure the activated-carbon filter first in the back using the hood's metal tabs and then in the front by pressing the two levers.

Check that:

•the unit is powered up.

•a speed has been set.

If the hood is not working effectively:

Check that:

•	the selected motor speed is sufficient to handle the
	amount of smoke and steam being produced.
•	the kitchen is adequately ventilated for the unit to take
	air in.

Replacing the bulbs

Disconnect the unit from the mains and remove the grease filter. Caution! Make sure the bulbs are cool before touching them.

1. Extract the guard by prising it out with a small flat head screwdriver or something similar.

2.Replace the faulty bulb. Use only bulbs of the

same type (for details, see the technical data in the following manual).

3. Refit the guard (push it in).

Replacing the lights LED *

The hood is fitted with a lighting system based on LED technology. The LEDs ensure optimal lighting, longer life and lower consumption compared with traditional lights. To replace them please contact the assistance service.

• the charcoal filter is not exhausted (filter version).

If the hood turns off during normal operation:

Check that:

•the unit is powered up.

•the circuit breaker has not tripped.

In case of faulty operation, before contacting Technical service, first disconnect the machine from the mains for at least 5 seconds by pulling its plug, then reconnect it. If the fault persist, contact Technical Service.

*Only available in certain models

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

14