Door Reversal

You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to carry out this procedure.

Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made.

WARNING: Switch off electrical supply and pull out the mains plug.

Remove all door furniture and all loose items/fittings from inside the fridge.

If you have previously set up and used the fridge and since decided to reverse the doors, you must remove stored food, wrap or cover it and place into insulated containers to keep cool whilst carrying out this operation.

1.Open the door as wide as possible.

Note : You may require assistance to do this:

2.Support the door and using a screwdriver, remove the screw securing the top hinge.

3.Lower the top hinge and carefully tilt the door to remove the hinge from the cabinet. Lift the door off the bottom hinge.

4.Remove the top hinge from the door.

5.Remove the spacing washers from the bottom hinge pin.

6.Use a flat blade screwdriver or a 5mm spanner, to unscrew and remove the bottom hinge pin.

8.Replace the right hand cover plate with its original screw.

7.Unscrew the fixing screw to remove the right hand hinge cover plate.

Then remove the door stop washer.

9.Take the plastic cap from the left hand cover plate and use it to fill the hole on the right hand cover plate.

MAINTENANCE	CLEANING&

10.Unscrew the fixing screw to remove the left hand hinge cover plate.

11. Firstly put the door stop		12. Replace the left hand
washer in position on		cover plate with its
the left hand hinge		original screw.
bracket and then screw
in the hinge pin.

13.Replace the spacing washers onto the hinge pin.