Hotpoint SCL 08 EB Remplacement de l’ampoule d’éclairage, Inspecting the seals

For more thorough cleaning purposes, the oven door may be removed:

Sliding rack kit assembly GB

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

F

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this sequence.

		A
Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Remplacement de l’ampoule d’éclairage

Pour changer l’ampoule d’éclairage du four:

1. Dévissez le couvercle en verre du boîtier de la lampe.

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

4.Finally, fit the frames on the spacers A.

2. Dévissez l’ampoule et remplacez-la par une autre de même type : puissance 25 W, culot E 14.

3. Remontez le couvercle à sa place (voir figure).

!Ne pas utiliser la lampe du four comme éclairage de la pièce.

!Do not place the sliding racks in position 5.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

11