Hotpoint SE861X/1 manual Maintenance and care

Maintenance and care

Switchingtheapplianceoff

GB

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

•The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. If these stains are difficult to remove, use only specialised products. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

•Ideally, the inside of the oven should be cleaned after each use, when it is still lukewarm. Use hot water and detergent, rinse and dry with a soft cloth. Do not use abrasive products.

•All accessories - with the exception of the sliding racks - can be washed like everyday crockery, and are even

Replacingthelightbulb

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder. 2. Remove the

light bulb and replace it with a similar one: Wattage 25 W, cap E 14.

3. Replace the glass cover (see diagram).

Sliding Rack Kit Assembly

To assemble the sliding racks:

dishwasher safe.

￿Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

To clean more thoroughly, you can remove the oven door.

1.Open the oven door fully (see diagram).

2.Lift up and turn the small levers located on the two hinges (see diagram).

	A
Left	Right guide
guide rail	rail

1.Remove the two frames, lifting them away from the spacers “A” (see figure).

2. Choose which shelf to

use with the sliding rack.

Paying attention to the

direction in which the

F

B

oDire
C
f	c
extra on
	ti
	c
	ti
	on

sliding rack is to be

extracted, position joint B

and then joint C on the

frame.

F

3.Grip the door on the two external sides and close it approximately half way. Unlock the door by pressing on the clamps F, then pull the door towards you lifting it out of its seat (see diagram).

To replace the door, reverse this sequence.

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

Inspecting the seals

Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest After- sales Service Centre (see Assistance). We recommend not using the oven until the seals have been replaced.

4. Finally, fit the frames on spacer A.

￿Do not place the sliding racks in position 5.

12