Hotpoint SD97 manual Electrical Connection

Page 15

Electrical Connection

Electrical connection

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Mounting the power supply cable

To open the terminal board:

Using a screwdriver, press on the tabs situated on each side of the terminal board cover.

Pull open the terminal board cover.

To mount the power supply cable, proceed as follows:

Unscrew the cable clamp screw and the contact screws.

Position the jumpers accordingly to the type of connection you wish to make as per the diagrams below.

Note: The jumpers are factory set for a 230V single phase connection.

Fasten the power supply cable in the corresponding cable clamp and close the cover.

Electrical Connections:

1

2

3

4

 

5

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

L

 

 

 

 

 

N

 

 

 

 

Voltage Frequency:

 

 

 

230 V-1+N 50Hz

Fuse Section:

 

 

 

 

32A 4mm3

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection.

If the appliance is installed with a junction box, an omnipolar circuit breaker - with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations (only use HAR - H 05 - RRF quality cables fitted with a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when replacing the oven lamp.

Using the appliance without correct earthing is highly dangerous.

IMPORTANT:

After connecting the appliance to the flexible cable, tighten all the screws on the terminal board.

This appliance conforms to the following EEC Directives:

Low Voltage Equipment 73/23/EEC 93/68/EEC

Electromagnetic Compatibility 89/336/EEC

93/68/EEC

Inner dimensions of the oven:

width 43.5cm

depth 40.0cm

height 32.0cm

Inner volume of the oven:

54 litres

Voltage and frequency of power supply:

230-240V

50-60Hz

2250-2400W

ENERGY LABEL

Directive 2002/40/EC on the label of electric ovens Norm EN 50304

Energy consumption for Natural convection

heating mode: a Convection

Declared energy consumption for Forced convection Class heating mode: u Baking

1 5

Image 15
Contents Electric Multifunction Oven Model SD97 Instructions for Installation and UsePage Contents Introduction Always For Your SafetyKnow Your Hob Control Panel Function Selector Temperature SelectorCooking without the Programmer Setting the digital clockControls Oven lightPizza Mode w Keep warm phaseFast cooking Mode Multi-cooking Mode bTo cancel a cooking schedule already programmed Minute Minder FeatureBuzzer volume How to set a programme to automatically switch off and onCooking Advice Pastry is too dark on top Pizza ModeBaking Cakes Pastry is too dryOven Convection Cooking ChartCare and Cleaning Installation Installation of Built-in OvensElectrical Connection Electrical Connection Page Page Repair Service and Information Help Desk After Sales ServiceRecycling & Disposal Information GuaranteeKey Contacts After Sales Service