Hotpoint 52TGW installation instructions Adapting to different types of gas

Installation

c)Minimum regulation of the hob burners:

• turn the tap to minimum;

• remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady.

!In the case of liquid gas, the regulation screw must be screwed in to

the bottom.

•check that the flame does not turn off when you turn the tap quickly from high to low.

d )Regulating the primary air of the burners:

The primary air of the

burners requires no regulation.

Adapting to different types of gas

In order to adapt the oven to a different type of gas with respect to the gas for which it was manufactured (indicated on the label), follow these simple steps:

a)Replacing the oven burner nozzle

•open the oven door fully

•pull out the sliding oven bottom

V

Z

V

•	Pry the fixing tab “V” and remove the oven burner
		GB
•	Unscrew the oven burner nozzle using the socket
	spanner for the nozzles “Z”, or a 7 mm socket
	spanner, and replace it with a nozzle suited to the
	new type of gas (see Table 1).
	Take particular care handling the spark
	plug wires and the thermocouple pipes.

•Replace all the parts, following the steps described above in the reverse order.

b )Minimum regulation of the gas oven burner with thermostat:

•light the burner as described in the paragraph “the oven knob” of the instruction booklet.

•turn the knob to Max for about 10 minutes and then turn the knob to the Min setting;

•remove the knob;

•regulate the screw positioned outside the thermostat pin until the flame is small but steady.

!In the case of liquid gas, the regulation screw must be screwed in to the bottom.

•check that the burner does not turn off when you turn the knob from Max to Min and and when you open and close the oven door quickly.

Adapting the gas grill to different types of gas

Replacing the nozzle of the grill burner:

•remove the screw and then slide out the grill burner “V” (see Fig. E);

•unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. F) or better still a 7 mm socket spanner; replace the nozzle with a nozzle for the new type of gas (see table 1).

7