Hotpoint dimensions HDA2000FAD/WH Hotpoint Built-In Dishwasher, Electrical Rating

HDA2000FAD/WH - Hotpoint Built-In Dishwasher

Dishwasher Dimensions (in inches)

Installation Information (in inches)

Wood Insert Cut-Out Dimensions (in inches)

25-1/8* 24

23-3/8*

24-3/4

34" MIN. adj. to 35"

			This wall area
	90°		must be free of
			pipes or wires
	24"	4	4
	MIN.
			4
Hot		5	5
water	34-1/2±1/4"
line on			6
	Underside 6
left	of countertop
	to floor

Countertop

90°

Electrical

wiring is

3" from cabinet

Electrical wiring on right

Door insert

Detail D

Access insert

B

APanel Thickness

3/4

Front

of

Panel

C

1-1/2

1/2

2	Plumbing and electrical
	service must enter
	inside shaded area

1/4

21-1/2*	*Add 1/4" for
	*rear insulation

3-1/4 4 (Adjustable)

19" MIN. from wall	24" From wall
	White (neutral)
	Ground
	Black (line)

24" MIN.

				Panel
Models/Kits	A	B	C	Thickness
GPF325 Kit	18-7/8”	23-9/16”	3-11/16”	1/4”
			4-1/4” to
GPF375 Kit	18-15/16”	23-5/8”*	3-3/4”**	3/4”

Electrical Rating
Voltage AC	120
Hertz	60
Total connected load amperage	8.6
Calrod® heater watts	500
For use on adequately wired 120-volt, 15-amp
circuit having 2-wire service with a separate
ground wire. This appliance must be grounded
for safe operation.

Note: Dishwasher must not be installed more than 10' from sink for proper drainage. All plumbing and electrical work must be in accordance with local codes. Dishwasher includes drain hose and leveling legs.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

*Bottom of panel must be notched 1-1/2" x 1/2" to clear access panel. (See illustration above)

**Adjustment required to match adjcent cabinets fronts due to leveling leg adjustment, 4" nominal.

Listed by

Underwriters

RLaboratories

Specification Created 10/00