Hotpoint FDW 75, FDW 70 manual To install the dishwasher in fully-fitted EN kitchens, 600

To install the dishwasher in fully-fitted EN kitchens.

Your free standing dishwasher can be installed in modern kitchens as follows:

•to stand next to furniture units or other electric household appliances (See Electrical Connection)

•to insert or built-in under the one worktop.

Should it be necessary to remove the top shelf of the dishwasher, proceed as follows:

1. unscrew the 2 rear screws and then, with a light push forward, let it slide out and remove it (see figure);

2. discard the polystyrene rectangle;

3. open the door and, after unscrewing the fixing screws, remove the 3 plastic plugs used to hook the shelf on (see figure);

4. glue on the small soundproofing adhesive spongy strip onto the top crosspiece (see figure);

5.tilt the appliance and glue on another one underneath the base.

6.Straighten up the appliance and adjust the front and back feet by unscrewing them in an anti- clockwise direction to raise the dishwasher to the required height.

7.Insert the appliance underneath the worktop (see figure), checking that the inlet and outlet pipes do not get bent or squashed (See Connecting the water inlet hose).

	600
820	600
.
min

600

8.Open the dishwasher door and glue on the two equal-sized adhesive spongy strips on the front edge of the appliance cabinet. Begin from the top without leaving out any spaces and make sure the strips adhere all along the length of the edge. A small part of the spongy strip protruding onto the outside will block any light left between the dishwasher and adjacent cabinets, thus improving the soundproofing.

!The dishwasher plug must be within access once the appliance has been built in, in order to allow for maintenance to be carried out safely.

!The structure of your dishwasher makes it

impossible to fit it under a hob.

6