Hotpoint HDA2000M warranty Display P~EL telb you if certiin things are wrong, Failure Occurred

The DISPLAY P~EL telb you if certiin things are wrong

	DISPLAY		WHAT IT ME~S	WHAT TO DO
	l-/l-		Electrical power has been	IF DISHWASHER WAS IN USE WHEN THE POWER
1-		/-	interrupted to the dishwasher but is	FAILURE OCCURRED:
			now back on.	1. Unlatch the door. Ifthedetergent cupis open, add
				detergent and close the cup.
				2. Relatch thedoorandtouch “START” then immediately
				touch “CLEAR/RESET~’ (This will pump any remaining
				water out of the machine. )
				3. Select thedesiredcycle and rerun the load.
				IF DISHWASHER WAS N~IN USE:
				1. Latch door.
				2. Select desired cycle.
				3. Runcycle when desired.
-/			The dishwasher is taking longer	This dishwasher is designed to automatically compensate for
~/			than normal to drain the water out.	longer than normal drain times, but cycle time will be
			This is usually caused by a blockage	extended. If this code continues to appear frequently then:
			in the drain air gap (seepage 18), a	1. Clean theairgap (seepage 18).
			kink in the drain hose, or a stopped
				2. Check forakinkin the drain hose.
			up drain pipe.
				3. Check plumbing for slow or stopped up drains.
				(N~E: Warranty service does not cover household
				drain problems.)
	--		Similar to blocked drain as	Locate and remove the blockage in the drain system as
/		l-’
			explained above, but the [2	explained above. To pump any remaining water out of the
--
			indicates that the drain is so	machine:
			clogged that the dishwasher cannot	1. Latch door.
			continue to operate in a satisfactory
				2. Select any cycle.
			manner. Dishwasher will stop.

3.Touch “START” andthen immediately touch “CLEAR/ RESET:’ (N~E: Warranty service does not cover household drain problems.)

---/ Dishwasher will not go into a drain Restart the cycle. If [3 repeats, call for service.

Iout period. Dishwasher will stop.

--

1- 1-/	There is too much water in the	The dishwasher is designed to automatically pump out extra
~	dishwasher. If [9 appears aftera	water as long as the door is latched. When you hear the motor
	power failure, this is normal and	stop running:
	the dishwasher will correct itself.	1. Unlatch the door and see ifall the water is gone. (It is
		normal for a small amount of water to remain in the bottom
		of tub to keep the water seal lubricated.)
		2. If you seewater entering the dishwasher, close and latch
		the door. Shut off the water supply to the dishwasher.
		3. If water is gone and no water is entering the dishwasher,
		restart cycle.
		4. If [+ repeats, shutoff the water supply to the dishwasher.
		Call for service.

8