Hotpoint HDA2000ZAD dimensions Dimensions in inches, Electrical Rating, Created 8/97

HDA2000ZAD—Built-In Dishwasher

Dishwasher Dimensions (in inches)

25-1/8* 24

Installation Information	Wood Insert Cut-Out
(in inches)	Dimensions (in inches)

23-3/8*

24-3/4

34" MIN. adj. to 35"

	90°
		24"
			MIN.
Hot
water
	34-1/2±1/4"
line on				6
	Underside
left
	of countertop
	to floor

2

This wall area must be free of pipes or wires

4	4
	4
5	5
	6
Plumbing and electrical
	service must enter
	inside shaded area

Countertop

90°

Electrical

wiring is

3" from cabinet

Electrical wiring on right

Door insert A

Access insert		C
	B

21-1/2*		*Add 1/4" for
		*rear insulation
	3-1/4	4 (Adjustable)

Electrical Rating
Voltage AC	120
Hertz	60
Total connected load amperage	8.6
Calrod® heater watts	500

19" MIN. from wall 24" From wall

24" MIN.

Note: Dishwasher must not be installed more than 10' from sink for proper drainage. All plumbing and electrical work must be in accordance with local codes. Dishwasher includes drain hose and leveling legs.

				Panel
Models/Kits	A	B	C	Thickness
GPF325 Kit	18-7/8”	23-9/16”	3-11/16”	1/4”
			4-1/4” to
GPF375 Kit	18-15/16”	23-5/8”*	3-3/4”**	3/4”

*Bottom of panel must be notched 1-1/2" x 1/2" to clear across panel

**Adjustment required to match adjcent cabinets fronts due to leveling leg adjustment, 4" nominal.

For use on adequately wired 120-volt, 15-amp circuit having 2-wire service with a separate ground wire. This appliance must be grounded for safe operation.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

For answers to your Monogram,®GE Profile Performance Series,™ GE Profile,™ GE, Hotpoint and RCA appliance questions, call GE Answer Center® service, 800.626.2000.

Listed by

Underwriters

RLaboratories

Created 8/97