Hotpoint RA720, RA724 owner manual ANTI-TIP Device Installation, Level the Range

Page 19
Anti-Tip device
Wood screw
Back of range
Wallboard

Installation Instructions

INSTALL THE RANGE

9 ANTI-TIP DEVICE INSTALLATION

WARNING:

•Range must be secured with an approved Anti-Tip device.

•Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

•After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

•This range has been designed to meet all recognized industry tip standards for all normal conditions.

•After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

•The use of this device does not preclude tipping of the range when not properly installed.

AMark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

9 ANTI-TIP DEVICE INSTALLATION

(cont.)

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

ESlide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

10LEVEL THE RANGE

For proper cooking and baking, the range must be leveled. Leveling legs are located on each corner at the base of the range.

AInstall the oven shelves

(see Using the oven section for instructions). Put a spirit level or a glass measuring cup partially filled with water on one of the oven shelves.

B

Locate the outside edge of the device 21⁄8″ toward the center of the range from the marked edge of the range.

Slotted head screw

Approx. 20°

2 1⁄8”

Anti-Tip device

Wallplate

Marked edge of range

BTurn the legs clockwise to raise the range and

counterclockwise to lower the range. Adjust the leveling legs until the range is level.

11 FINAL INSTALLATION CHECKLIST

CUsing the device as a template, mark the position of the hole for the screw.

DFor wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 11⁄2″

lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended

size hole for the hardware.

19

• Check to make sure the circuit breaker is closed

(RESET) or the circuit fuses are replaced.

• Be sure power is in service to the building.

• Check to be sure that all packing materials

and tape have been removed. This will

include tape on metal panel under control

knobs (if applicable), adhesive tape, wire

ties, cardboard and protective plastic. Failure

to remove these materials could result in

damage to the appliance once the appliance

has been turned on and surfaces have heated.

• Check to make sure that the Anti-Tip device

is securely installed.

• Be sure all range controls are in the OFF

position before leaving the range.

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Write the model and serial numbers here Model # Serial # 20″ and 24″ Compact Electric RangesAll ranges can tip and injury could result ANTI-TIP DeviceInstallation Instructions Operating Instructions Care and CleaningGe.com Medium High heats Consumer SupportUsing the surface units Tips Installation Instructions Oven Shelf Positions Using the ovenInstructions Safety Instructions Oven Temperature ControlPreheating Using the oven for baking or roastingHow to Set Your Oven for Baking or Roasting Shelf PositionsType of margarine will affect baking performance Adjust the oven thermostat-Easy to do yourselfSafety Instructions Consumer Support Troubleshooting TipsClose the door. Always broil with the door closed Using the oven for broilingHow to Set Your Oven for Broiling Broiling GuideSurface Units and Drip Pans Care and cleaning of the rangePorcelain Enamel Cooktop Oven ShelvesOven Heating Elements Lift-Up Cooktop SafetyTroubleshooting Tips Lift-Off Oven DoorPorcelain Oven Interior Instructions Safety Control KnobsInstructions Painted SurfacesRead these instructions completely and carefully For Your SafetyBefore YOU Begin ANTI-TIP DeviceParts Included Materials YOU MAY NeedTools YOU will Need Prepare the OpeningElectrical Requirements Electrical ConnectionsDo not discard this screw Power Cord and Strain Relief InstallationAfter Do not remove the ground strap connectionCut and discard the ground strap. do not Discard ANY Screws BeforeReplace the Wire Cover Wire Conduit InstallationWire used, location and enclosure Level the Range ANTI-TIP Device InstallationProblem Possible Causes What To Do Before You Call For Service…We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration We Will Replace Electric Range WarrantyWhat is Not Covered Care and CleaningReal Life Design Studio Schedule ServiceParts and Accessories Consumer Support GE Appliances Website

RA720, RA724 specifications

The Hotpoint RA724 and RA720 refrigerators exemplify modern efficiency and innovative design, making them ideal choices for any kitchen. Both models are engineered to provide optimal food storage solutions while ensuring energy efficiency and user-friendly operation.

The Hotpoint RA724 is particularly notable for its spacious interior, designed to accommodate large quantities of groceries with ease. Featuring adjustable shelving, users can modify the layout to fit taller items or create more space for bulk purchases. The model boasts a generous fresh food compartment and a separate freezer section, providing ample room for various food items.

One of the standout technologies present in both the RA724 and RA720 models is the Total No Frost system. This technology eliminates the need for manual defrosting, as it prevents ice buildup within the freezer. This not only saves users time but also helps maintain optimal temperature levels, ensuring that food is stored at the right temperature, thereby prolonging its freshness.

Energy efficiency is another critical feature of these refrigerators, as both the RA724 and RA720 are designed to minimize energy consumption without compromising performance. The A+++ energy rating indicates that these appliances are among the most eco-friendly options available, which can significantly reduce electricity bills over time.

Additionally, both models come equipped with a Multi Air Flow system that facilitates even air distribution throughout the refrigerator. This ensures that every corner of the fridge maintains a consistent temperature, greatly enhancing food preservation while reducing spoilage.

The user-friendly digital LED display is another feature that makes the Hotpoint RA724 and RA720 stand out. This intuitive control panel allows users to easily adjust temperature settings for both the refrigerator and freezer sections, ensuring that your food remains at optimal conditions.

In terms of design, both models boast a sleek and modern aesthetic that can seamlessly blend into any kitchen décor. With a variety of color options available, users can choose a finish that complements their kitchen style.

In summary, the Hotpoint RA724 and RA720 refrigerators are designed with the modern consumer in mind, featuring spacious interiors, innovative technologies like Total No Frost, energy efficiency, and stylish designs. They are excellent choices for anyone looking to enhance their kitchen with reliable and functional appliances.
Top Page Image Contents