Using your Sunbeam Open All
1.Ensure that the Cutting Assembly is correctly positioned. (See figure 1.)
Release Button |
Keyhole |
Drive Wheel |
Figure 1 |
The Cutting Assembly fits into the keyhole opening at the top of the Open All™ can opener, above the Drive Wheel. Slide the Release Button to the right as the Cutting Assembly is inserted, it will “click” into position, with the release button returning to its original position.
2.Insert the plug into a
3.Hold the Lever in the upright position. Position the can under the Support Bar so that the rim of the can rests on top of the Drive Wheel, tilting the can at a slight angle towards the main body of the unit. (See figure 2.)
Support | Lever | |
Bar | ||
| ||
| Drive | |
| Wheel |
Figure 2
4.Firmly press the Lever down. This action will bring the blade down and pierce the lid of the can and start operating the motor to turn the can. Ensure the Magnetic Lid Holder is in contact with the lid of the can. (See figure 3.)
Figure 3
5.When the can begins to turn, it is no longer necessary to hold down the Lever.
6.When the can is fully opened, the Open All™ can opener will stop automatically.
4