Using your Sunbeam Verve Iron (continued)
Dry ironing
Follow steps 1 and 2 above.
3.Select DRY on the steam dial.
This will cut off the steam flow if there is water in the tank.
Using the shot of steam
The shot of steam can be used when dry
or steam ironing, when the temperature dial is set to any temperature within the steam
band or above the two dot (••) setting.
1.Ensure the tank is at least 1/4 full of water.
2.Select the desired temperature and wait until the thermostat light goes out.
3.Press the shot of steam button several times with the iron on the soleplate to prime the pump.
Note: If the tank has run dry, it may be necessary to
the iron with water.
Using the spray mist
The spray mist can be used whether dry or steam ironing to
fabrics.
1.Ensure the tank is at least 1/4 full of water.
2.Press the spray button during ironing to release a fine mist from the spray nozzle.
The safety auto-off feature
The safety
The iron will automatically shut off if left on the heel rest (vertical) for 15 minutes, or in the ironing position (horizontal) for 30 seconds, without being moved.(See figure 2).
The thermostat and power lights on the handle will flash to let you know that you have left the iron unattended.
Power to the iron's heating element will be cut.
Once the iron is moved the power will reconnect. Allow the iron to heat until the thermostat light goes out, and continue ironing as normal.
15 minutes | 30 seconds |
Figure 2
7