DeLonghi ESAM04.350 manual Making Drinks with Milk, Filling and attaching the milk container

it. This could damage the appliance.

•Never use more than one level

measure or it could dirty the inside of the machine or block the funnel.

Please note!

If you use pre-ground coffee, you can only make one cup of coffee at a time.

1.Press the (C11) button: “Pre-ground” flashes on the display.

2.Put one level measure of pre-ground coffee into the funnel (fig. 14).

3.Place a cup under the coffee spouts (fig. 9).

4.Press the delivery button (fig. 2).

5.Preparation begins. A bar appears on the display and gradually fills as preparation progresses.

Once the coffee has been made, the appliance prepares for use again.To disable the pre-ground coffee function, press the or button again.

	MAKING DRINKS WITH MILK
		Please note!
s	To avoid producing milk with poor froth or large bubbles,
	always clean the milk container lid and hot water nozzle as
	described in the section “Cleaning the milk container” and
	“Cleaning the hot water/steam nozzle” (page 16).

Filling and attaching the milk container

1.Remove the lid (fig. 16);

2.Fill the milk container with a sufficient quantity of milk, not exceeding the MAX level marked on the handle (fig.

17).

Please note!

•For a denser more even froth, you must use skimmed or partially skimmed milk at refrigerator temperature (about 5°C).

The quality of froth can be adjusted during delivery

by moving the regulator slightly towards the word

”CAFFELATTE for less froth.

Moving it towards the word CAPPUCCINO obtains a more froth.

- froth

+ froth

•If “Energy Saving” mode is enabled, you may have to wait a few seconds before the first cappuccino is delivered.

During this time, “Preparation underway...” is displayed.

3.Make sure the milk intake tube is correctly inserted in the bottom of the milk container lid (fig. 18).

4.Place the lid back on the milk container.

5.Remove the hot water spout from the nozzle (fig. 19).

6.Attach the container to the nozzle, pushing as far as it will go (fig. 20).

7.Follow the instructions for each function.

Making Cappuccino of Latte Macchiato

1.Attach the milk container (see previous section) and place a sufficiently large cup under the coffee spouts and milk spout.

2.Place the frothed milk regulator between “CAPPUCCINO” and “CAFFELATTE” (fig. 21).

3.Press the CAPPUCCINO button (fig. 22). “CAPPUCCINO” is displayed, together with a progress bar which fills gradually as preparation proceeds.

4.After a few seconds, frothed milk flows out of the milk spout into the cup below. If the froth is not satisfactory, move the milk regulator towards “CAPPUCCINO” (= + froth) or towards “CAFFELATTE” (= - froth). Milk delivery stops automatically and coffee delivery begins.

5.The cappuccino is ready. Sweeten to taste and, if desired, sprinkle the froth with a little cocoa powder.

Please note!

•If you want to interrupt preparation during delivery, press the CAPPUCCINO button.

•At the end of delivery, to increase the quantity of coffee in the cup, just press (within 3 seconds) the CAPPUCCINO button.

•Do not leave the milk container out of the refrigerator for longer than strictly necessary. The warmer the milk (5°C ideal), the poorer the froth will be.

Making frothed milk (without coffee)

To make frothed milk, proceed as described in the previous section, placing the milk froth regulator in the CAPPUCCINO position and pressing the CAPPUCCINO button twice consecutively (within two seconds) (fig. 22).

The appliance displays “Frothed milk” .

Please note!

If during delivery you want to stop making milk or coffee, press the CAPPUCCINO button once.

Preparing milk (unfrothed and without coffee)

Proceed as described in the previous section, placing the milk froth regulator in the CAFFELATTE position.

13