DeLonghi EC860 manual Program the amount of coffee in the cup, Warmer cup fig

Instructions for use en

•Position the cup under the filter-holder spouts. It is advised to heat the cup before making the coffee, rinsing it with hot water.

•Ensure the lights relative to the coffee buttons are on,

press the coffee button : the appliance proceeds and interrupts automatically.

Please note:

•While the machine is preparing the coffee, it can be stopped at any time by pressing the previously pressed coffee button.

•Once delivery is completed, if you would like to to increase the amount of coffee inside the cup, keep the previously pressed coffee button pressed (within 3 seconds) of delivery.

•Turn the handle from right to left to release the filter- holder.

Scalding hazard!

To avoid sprays, never release the filter-holder while the machine is delivering and wait a few seconds after delivery.

Program the amount of coffee in the cup

The machine has been set by default to deliver standard amounts of coffee. If you would like to amend to amend these quantities, proceed as follows:

1.Place a cup under the coffee spout.

2.Keep the button to be programmed ( or ) pressed. The machine starts delivering coffee.

3.As soon as the wanted amount of coffee in cup is reached, release the button: delivery stops.

The machine is now re-programmed according to the new amount.

Warmer cup (fig. 32)

The warmer cup can be switched on by pushing the but- ton: leave the cups on the appliance as long as they are warm. This is useful to have warmer coffee.

Important!

When the appliance turns to low power function or stand-by the cup warmer is still on until you don’t press the button to switch it off. Pay attention not to touch it as it is hot.

How to prepare milk-based drinks

To avoid milk with poor froth or large bubbles,­ always clean the lid of the milk and the hot water nozzle as described in the “cle- aning the milk container” at page 13.

1.Remove the lid (fig. 17);

2.Fill the milk container with sufficient amount of milk, not

exceeding the maximum of 0.5 l (fig. 18). Remember that every notch on the side of the container corresponds to 100 ml of milk.

Please note!

•For a more dense and homogenous froth, It is recommended to use skim milk at refrigerator temperature (about 41° F / 5° C).

3.Make sure the milk intake tube is correctly inserted in the bottom of the milk container lid (fig. 19).

4.Place the lid on the milk container.

5.Remove the hot water spout from the nozzle by pushing the button (fig. 20).

6.Attach by inserting the container to the nozzle (fig. 21).

7.Set-up the machine to make coffee (see “how to prepare espresso” pg. 10).

8.Place the cup for cappuccino or the glass for Latte Macchiato under the coffee spout and adjust the milk spout (fig. 22). If using tall cups or glasses, reposition the cup-holder, as shown in fig. 23).

9.Vary the froth regulator depending on the amount of froth wanted and type of milk used (fig. 24).

To prepare the Cappuccino: press button .

To prepare the latte macchiato: press button .

9.After having delivered the frothed milk, the machine automatically prepares the coffee.

Please note!

•For a hotter cappuccino, it is advised to press the CLEAN button to heat the ducts of the milk frother device (see successive paragraph).

•To prepare the cappuccino or the latte macchiato, the appliance performs 2 deliveries: first the milk and subsequently the coffee. If you would like to interrupt the delivery in progress, press the previously pressed button.

•Once delivery is completed, if wanting to increase the amount of milk or coffee inside the cup, keep the button (within a few seconds) relative to the preparation in progress pressed.

•Do not leave the milk container out of the refrigerator for too long: the higher the milk temperature (41° F / 5°C is ideal), the poorer the quality of the froth.

Cleaning the milk frother device using the CLEAN button After every use of the milk functions, perform cleaning to eliminate the milk residues as follows:

1.Leave the milk container inserted in the machine (it is not necessary to empty the milk container);

11