Dakota Alert WHT-3000 owner manual Operation, Coding the transmitter

3to

4 ft

figure 1

Operation:

The control box is powered by one 9-volt battery.

Coding the transmitter:

1.Open the transmitter box. The first thing you will see is the air switch (Figure 2). Directly below the air switch is the transmitter’s radio (Figure 3).

2.Locate the dip switches on the radio .

3.Switches 1-8 are for the frequency setting (256 combinations). They are set at the factory to the on position in both the receiver and transmitter. If needed, set switches 1-8 ,to match the eight switches in the receiver.

4.Switches 9 and 10  are for the channel setting on the transmitter. Use these to set the tone you prefer. The four channels are listed in the table on page 5:

3.