Switching on
•Plug the power base into the mains socket.
•Place kettle on power base.
•Press the ON/OFF switch down (fig.4) to switch the kettle on.
•The switch will light up.
•The kettle will automatically switch off once the water is boiled
(the ON/OFF switch will click upwards and the light will go
out).
• To turn the kettle off before the water boils, you may move theFig.4 ON/OFF switch up to the OFF position, or simply lift the kettle
from its base - it will switch off and the switch will return to the OFF position automatically.
Pouring
•Remove the kettle from the power base and carefully pour out the water. Do not tilt the kettle suddenly or pour water out at too sharp an angle.
•When you lift the kettle from the base, you may see moisture on the top surface of the base.This is condensation from the steam that causes the kettle to turn off automatically after boil- ing. Steam is allowed to escape via vents in the underside of the kettle. Condensation on the base is perfectly normal, and should not be a cause for alarm.
Safety devices
1)Automatic ON/OFF switch
Your kettle is fitted with an ON/OFF switch which automatical- ly switches off once the water has boiled. If the kettle has just boiled, wait a minute or so before
2)Safety cut-out
If the kettle is switched ON with too little or no water, it is protected against damage by a safety
If this
3)If kettle is lifted from base while operating (ON), it will auto- matically switch off.
4 | Kettle KBR3015 |
|