Maintaining Your Lifestyle® 25 System
Troubleshooting
Problem | What to do |
|
|
System does not function | • Make sure the power connector is inserted securely into the music center, the power cord |
at all | is inserted securely into the Acoustimass® module, the power pack and power cord are |
| plugged fully into operating AC wall outlets. |
| • Be sure to select a source (CD, AM/FM, etc.). |
| • Unplug the music center power pack for a minute, then reconnect it. This allows the unit |
| to reset itself after a power surge or power interruption. |
| • If the system is not responding, press STORE, ERASE, and ON/OFF (on the music center) |
| at the same time, to reset the system. |
|
|
No sound | • Increase the volume. |
| • Check to see if MUTE is lit on the display. If it is, press the MUTE button on the remote |
| control to unmute the sound. |
| • Make sure the audio input cable is firmly seated in the music center SPEAKER ZONE 1 |
| jack and the |
| module AUDIO INPUT jack. |
| • Check speaker connections. |
| • Turn the music center off for ten seconds, then on again, to restore communication |
| between the music center and the speakers. |
| • Check the connections for any external components. Make sure to select the correct |
| source for the desired input. |
| • Be sure the CD is placed correctly, |
| inserted properly in the music center. |
| • Disconnect any headphones. |
| • Connect the FM and AM antennas. |
|
|
No sound from | • Make sure the center cube cable is connected at both ends. |
center speaker | • Select STEREO+CENTER |
|
|
Too much sound | • In STEREO+CENTER mode, press SURROUND – to decrease center speaker volume. |
from center speaker | • Press and hold the STEREO+CENTER |
| the factory preset center volume setting. |
|
|
No sound from | • Select SURROUND |
surround speakers | • Press SURROUND +. |
| • Press and hold the SURROUND |
| factory preset surround volume setting. |
| • Make sure the video sound source is stereo and |
| used (TV, VCR, laserdisc player) is stereo. |
|
|
Surround speakers | • In SURROUND mode, press SURROUND |
are too loud | • Make sure that the left and right front speakers are connected to the front speaker jacks |
| (blue) and the left and right surround speakers are connected to the surround speaker |
| jacks (orange). |
| • Press and hold the SURROUND |
| factory preset surround volume setting. |
|
|
26 | December 20, 2001 | AM187718_01_V.pdf |