Start-up
Before commissioning, remove all paper and plastic packaging from the appliance. Check to ensure that the appliance is not damaged and the door closes properly. Clean the inside of the appliance (see chapter "Cleaning and Care").
Switching on
Attention!
Wait at least 4 hours for the first
1.Connect the appliance via the power cable with a properly connected and earthed 230 V mains power socket.
2.Bring the temperature controller 5 into the de- sired position. The further you turn the regulator clockwise, the lower the temperature will be in- side the appliance.
• MIN = relatively low cooling
•= normal setting
• MAX = lowest temperature, maximum cooling
•The appliance will take about four hours to re- ach the desired interior temperature. Please wait this long until you start to fill the appliance with frozen foods.
Note
The cooling temperature is influenced by, ...
•... how high the ambient room temperature is,
•... how much food is stored in the appliance,
•... how you have set the appliance up.
Please take note of all of these factors when setting the cooling temperature. Do not be afraid to experi- ment a little to find out which cooling temperature best suits your needs.
Note
With the "super freeze function" you can in a short time set the maximum cooling performance. In this case it does not matter at what level the temperature regulator 5 is set.
Place the switch “Super Freeze” 4 at the ON posi- tion if you want to cool the appliance down before freezing fresh foods (see chapter "Freezing fresh foods").
Always distribute the food to be frozen evenly in the freezer compartments 8.
Later, do not forget to place the switch 4 back into the OFF position.
Control lamps
•The operating control lamp (green) 3 glows constantly when the appliance is connected to the mains power supply. When you disconnect the appliance from the power mains or there is a power failure, then the lamp extinguishes.
•The temperature control lamp (red) 2 indicates a temperature in the freezer compartment that is too high. These may be the reasons for it:
-the appliance was just connected to the mains power supply,
-a larger quantity of food is being stored in the appliance than is admissible as given on the typeplate,
-the appliance door has been left open for too long,
-the temperature controller has just been turned clockwise and the appliance has not yet reached the desired temperature.
•The "Super Freeze" control lamp (yellow) 1 glows when the "Super Freeze" switch is brought into the ON position - the compressor then operates continuously.
- 5 -